Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Replaced The conduit Carrier Mid, Conduit Spray Arm Mid and the Middle Spray Arm Assembly. All in less than 1/2 hour. Although, I think the main problem was the Conduit Carrier Mid which was distorted. By the way, I was surprised that I received my parts the very next day after I ordered them. Read more
This was not an obvious source of a leak. The Tower Heater Assembly Nut developed a crack over time due to heat exposure. So the leak was gradual slowly getting worse over time. It was a hairline crack that ran down one of the edges of the nut making it hard to see. In talking to a pro he said it isn't a common problem. It is all the way in the back of the bottom of the dishwasher so it is not something you can see without pulling the dishwasher out and running it. The repair itself is easy. I... Read more
The main conduit was broken and the pump connector had a hole in it. The pump also was showing signs of leaking. I completely disassembled the dishwasher cleaned everything and reassembled. The repair videos are a big help. Thank you. Read more
Simple 30 sec and $7 fix Read more
This was very simple. Thgey just popped back into place asnd the cap screws in. Read more
Found a service manual that is close enough to my GE dishwasher. Service Manual for GE Dishwasher-EDW4000 was found on the following webpage. http://www.applianceaid.com/pdf/serv-man-EDW4000.pdf Gives enough information to test out the dishwasher. Read it, check out Factory Test Mode. GE should have given this out as a normal User Manual. The usual user manual lack anything to help troubleshoot a problem. Read more
This is a genuine OEM replacement lower spray arm bearing sourced directly from the manufacturer for use in dishwashers. The lower spray arm spins to distribute water to the dishes during the wash cycle. Thus spray arm bearing supports the spray arm and lessens the friction, which allows it to spin more easily. If the dishes are not clean after the wash and rinse cycle, or the arm is making loud noises, the spin arm bearing may need to be replaced. This bearing is a small metal part that may wear over time. If the bearing is distorted or damaged, the arm will not sit level, and spinning may be very loud, or it may not spin. The spray arm bearing should be replaced. Turn off the breaker or disconnect the power to the dishwasher. Open the dishwasher and pull the bottom rack out. Turn the lower spray arm counterclockwise to remove it. Use a telescoping magnet to pull the bearing up from the hole in the middle. Install the new bearing and reinstall the spray arm. Put the dishrack back inside and reconnect the power.This lower spray arm bearing is a gray metal part that is sold individually. It is designed for use in dishwashers designed by General Electric and Hotpoint.
Replaced all the related parts. Read more
The video provided by Appliance Parts Pros is excellent! I followed its steps. The one problem I had was getting the ribbon to disconnect. The plastic pieces that hold it together are fragile and broke. So, instead of disconnecting the ribbon I placed a kitchen stool in front of the dishwasher door and laid the top portion on it. Then I was able to remove the handle and change out the actuator. The handle was fine and did not need replacing; a tab on the actuator had broken. (In my opinion... Read more
Ordered parts and watched video. It was not the exact same GE as my model. Had to guess at times. Took a couple of hours, but the repair was great. Read more