Gtds825gdmc Parts

Size: 8-32 t. Includes 12 screws.

Dryer not heating or shutting off unexpectedly? A faulty fuse holder can disrupt circuit protection. This bracket secures your thermal fuse connection.

If your dryer runs too long or overheats, the inlet thermistor may have failed. This sensor monitors incoming air temperature for accurate drying.

This blower wheel is the replacement fan wheel that moves air through the dryer to support efficient drying and proper venting. Restores airflow from the dryer drum to the exhaust system for more consistent drying performance. What it does:

• Spins on the motor shaft to draw air over the heating element and through the drum.
• Restores proper airflow to reduce long dry times and improve drying consistency.
• Replaces damaged or unbalanced wheels that cause vibration, wobble, or unusual noise.
• Helps prevent overheating by maintaining proper venting when working with a clean vent system.

• Disconnect power to the appliance before beginning any repair.
• Access typically requires removing the dryer front or rear access panel and the drive belt or motor mounting hardware; follow the model service manual.
• Inspect the motor shaft and blower housing for wear, lint buildup, or obstructions and clean the vent system while replacing the wheel.
• Replace or repair worn motor bearing or shaft components to prevent repeat failures.

Mounting screw hardware for ranges and cooktops. Replace missing, stripped, or corroded screws used to secure panels, brackets, or components.

10-16 x 1-1/4 inch screw for securing dryer panels, brackets, and internal components. Replace missing, stripped, or damaged screws during repairs.

Decorative top trim panel that covers the dryer's upper edge. Replace if your trim is cracked, chipped, discolored, or missing for a clean finish.

Duct assembly that channels hot air from the heating element to the drum in your dryer. Replace if cracked, damaged, or causing poor airflow.

This is a retainer clip that secures the drum support roller to its shaft inside the dryer. It keeps the roller in place so the drum can rotate smoothly during operation. Replace this retainer if the drum roller has come loose, the drum wobbles or makes thumping noises, or the roller shifts out of position.

Replacement mounting screw for dryer front panel assembly. Secures front panel to cabinet. Needed when original screw is stripped, missing, or lost.

Replacement shaft for dryer drum support rollers. Installs through the roller assembly to mount it to the dryer frame. Order when shaft is bent or worn.

Fix dryer not heating or shutting off mid-cycle with this sensor wire harness assembly. Connects temperature and moisture sensors to control board.

Seals the blower-to-exhaust duct connection in your dryer. Replace if torn, brittle, or causing heat loss and longer dry times. Confirm fit by model.