Gtr104aso Parts

This wiring harness is the appliance connector assembly that delivers power and signals between controls and components, restoring reliable electrical connections for proper operation. What it does:

• Routes electrical power and control signals between the control board, switches and other components.
• Replaces damaged or corroded wiring that can cause intermittent operation or component failures.
• Helps stop issues like control unresponsiveness, appliances that won't start, or circuits that short due to exposed wires.
• Ensures correct connector fit and secure pin contact to maintain safe electrical continuity.

• Disconnect all power (unplug or switch off the breaker) before starting any repair.
• Compare connectors and wire lengths to the original harness to fit before installing.
• Route harness carefully to avoid sharp edges, heat sources, or pinch points; secure with original clips/fasteners.
• If you find melted insulation, exposed conductors, or repeated failures, replace any damaged components and proper operation after reassembly.

The Washer Drain Hose is an OEM replacement part for Frigidaire washing machines. It is a flexible, 7 ½ ft plastic hose that connects the washer tub to the household drainage system. The drain hose removes water from the washer at the end of each cycle.

Symptoms of a faulty drain hose include:

• Water failing to fully drain or continuously draining
• Wet  flooring around the washer due to leaks
• Excess water left standing in the washer tub after cycles
• Reduced washing performance due to inadequate drainage

Causes of a bad drain hose include kinks or bends that restrict water flow, cracks or holes from wear and tear, and blockages from accumulated debris. These issues can compromise the hose's ability to drain water properly.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This OEM replacement part is a drive motor for washers. The drive motor is the main engine that propels the washer tub to spin and perform its primary function of washing clothes. Over time, a drive motor can lose power or stop working altogether due to excessive wear and tear. If the washer is no longer spinning or not working as efficiently as it once did, the drive motor will need to be replaced. Thankfully, replacing this part is a relatively easy fix.To begin, start by unplugging the washer. Once unplugged, move the washer away from the wall to gain access to the back panel. Uninstall the back panel by removing the mounting screws. Once removed, gain access to the drive motor and remove the screws that attach it to the washer. After unthreading the screws, pull the drive motor out of its place and position the new motor in its original position. Fasten the mounting screws and make sure the motor is securely attached. This genuine replacement part is sold individually and is compatible with Frigidaire, Electrolux, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore brand washers.

Outer door panel that replaces a damaged or worn outer door surface, restoring the appliance's finished exterior and protecting inner door components. Ideal when the exterior is dented, scratched, or cosmetically damaged. What it does

• Provides the finished exterior surface for the appliance door and protects internal door components from damage.
• Restores appearance after dents, scratches, rust spots, or cracked paint.
• Re-establishes mounting surfaces and edge trim where tabs or attachment points are intact.
• Helps prevent further corrosion or moisture intrusion into the door assembly.

• Disconnect power (and water, if applicable) and follow before starting; use proper PPE.
• Door removal and panel replacement often require basic hand tools; save and reuse original screws, handles, and trim unless replacements are supplied.
• Transfer any hardware, insulation, or inner-door pieces from the old door to the new panel as required.
• Large panels can be awkward—have a second person assist to avoid dropping or bending the panel.