Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Cushions where the washer lid meets the top panel to soften closure and protect the finish. Replace worn, cracked, or missing bumpers to reduce noise.
The problem was most likely the evaporator fan motor but it could have been a bad blade, loose parts or bad motor mounts. Hard to tell without taking everything apart and inspecting. Since fridge was 17 years old I decided to order the entire evaporator fan assembly as shown in the parts diagram including fan blade, motor brackets, motor, motor mounts, screws, etc. Getting to the assembly involved removing the ice maker unit plus the entire rear inside of the freezer section. Parts cost around... Read more
Fridge won't cool or runs constantly? This temperature control thermostat senses compartment temp and cycles the compressor. Moderate DIY repair.
Replaced the thermostat. Read more
Creates an airtight seal around your refrigerator door to prevent air leaks. Replace if you notice moisture, poor sealing, or temperature issues.
We followed the video that you had on your website. We removed the door, removed the old gasket, and installed the new one. It took about 20 minutes total. Piece of cake! Read more
8-18 CA HX 1/2 S
Replacement went good. The fan was perfect match. I am glad I ordered the two grommets, because the other ones were worn. I found this when dismantling. The blade was replaced as well. Read more
A replacement reversible plug door that covers and protects the appliance power inlet while letting the cord exit left or right for tidy cord routing. Restores a clean back panel appearance and helps keep the power connection protected from debris. What it does:
Secures refrigerator wiring to prevent chafing and vibration noise. Replace when damaged or missing to keep harnesses organized. Confirm fit by model.
Refrigerator not cooling or running constantly? A damaged condenser coil prevents proper heat release. This assembly restores cooling efficiency.
Mounting standoff spacer secures internal components, panels, and circuit boards inside your refrigerator. Replace if cracked, broken, or missing.
Since the compressor was still working, I guessed that either the interior fan was bad or the main control board. Since fans are usually very reliable, I decided to replaced the main control board. Immediately after replacing the board, the refrigerator began working normally. Thank goodness that solved the problem because replacing the board is much easier that replacing the fan on my refrigerator. Read more
I purchased main control board/defrost limiter thermostat and defrost heater I only needed the defrost limiter thermostat fairly easy to do simple tools needed. I would rate this job as a 6 or 7 on a scale of 10 10 being most difficult the only thing that took time was defrosting the evaporator I used a small steam cleaner worked well Read more
Secures water tubing to fittings in refrigerators and dishwashers. Replace if leaking, tubing slips off, or clamp is cracked. Confirm fit with model number.
When moving a "Scratch & Dent" Ref we broke the coupling on the back for the water line. We purchased new and repaired ourselves! Read more
Size: 8-32 t. Includes 12 screws.
Stainless steel fastener that secures your refrigerator door handle to the door assembly. Replace when original is stripped, missing, or damaged.
Replaced upper and lower thimble's, lever arm, cam closure. Door stop was not the problem, but ordered it and replaced it too. The door of course has to come off, remove the top hinge, and lift it away. Lubricated moving parts with silicone spray. Be sure and put the door back in the open position, so the lever arm and cam closure can properly interact, then close the door. Remove the plastic grate at the bottom to get at the lever arm. Presto. Problem gone. Don't put excessive weight... Read more
Replacement mounting screw for securing panels, trim, and internal components in appliances. Needed when original screws are stripped, lost, or damaged.
Sheet metal screw secures refrigerator panels, trim, and brackets. Replace missing, stripped, or corroded screws to restore proper fit and assembly.
Replacement 8-18 x 9/16 machine screw for securing panels, brackets, and internal components. Needed when fasteners are stripped, missing, or worn.
Originally replaced the door and spring but it still would not close. This time, replace the solenoid and it works great!!! Read more
Covers unused hinge or mounting holes on refrigerator doors after reversing door swing. Replaces cracked, missing, or damaged plugs for a clean finish.
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.