Jgs760selss Parts

This tubular broil burner delivers the concentrated heat used for broiling in gas ovens, restoring high-heat cooking performance for crisping and browning. Replace a damaged or worn broil tube to recover even broil results. What it does

• Provides the primary heat source for the oven's broil function
• Replaces a cracked, warped or visibly damaged broil tube
• Restores consistent top-heat for browning and finishing foods
• Addresses symptoms such as weak or no broil heat and uneven broiling

• Disconnect power and shut off gas supply before beginning service
• Handle the tube carefully to avoid bending or damaging terminals
• Verify proper fit and orientation against the oven's broil bracket and igniter

The Convection Motor is an OEM part for GE gas ranges. It is the component responsible for circulating hot air around food inside the oven cavity during convection cooking cycles. 

Causes of a bad convection motor include failed windings, worn bearings, or damage from excess heat over time.

Symptoms of a bad convection motor include:

• Inability to select convection cooking functions 
• Lack of air movement inside the oven
• Slower than normal cooking times 
• Uneven baking or roasting results

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Seals between the oven light lens and liner to keep grease and moisture out. Replace if damaged, cracked, or no longer sealing properly.

Exterior trim piece that finishes and protects your gas range vent opening. Replace if cracked, dented, or missing to restore a clean appearance.

Seals your oven door to retain heat, smoke and odors for even cooking. Replace when worn, cracked or allowing heat to escape. Verify fit with your model.

If your right-front burner won't ignite, has a weak or uneven flame, or gas flow is inconsistent, this orifice holder secures the burner orifice.

Left hand side

Restore proper coverage and support behind the control area on your gas range. This upper manifold panel mounts the valve assemblies and improves appearance.

Machine screw that secures panels, trim pieces, and brackets on ranges. Replace stripped, damaged, or missing screws to keep components properly fastened.

Base spacer for gas ranges. Installs at the bottom of the range to provide proper spacing and support. Replace if cracked, broken, or missing.

Positions and supports internal components to maintain proper alignment and clearance. Replace if cracked, broken, or missing to restore stability.

Fix a non-working convection fan or cooling blower with this range blower motor wiring harness. Common repair for ovens with electrical failures.

This dual plunger switch completes dispenser controls when the dispenser lever is pressed, restoring proper water and ice dispensing response. It replaces a worn or failed dispenser actuator switch to help the dispenser register lever movement. What it does:

• Acts as the dispenser lever switch assembly, closing circuits when the lever/plunger is depressed
• Controls water and/or ice dispense signals to the dispenser control board or valve
• Commonly linked to symptoms such as no water or ice when pressing the dispenser, intermittent dispensing, or unresponsive dispenser lever
• Helps restore reliable electrical contact for dispenser operation when the original switch is faulty

• One dual plunger switch assembly

• Disconnect power to the appliance before beginning any work
• Shut off water supply if removing water-connected components near the dispenser
• Access typically requires removing the dispenser bezel or front panel to reach the switch; handle panels and connectors gently
• Reconnect wiring exactly as removed and verify operation before reassembling all panels