Jt5500sp3ss Parts

The Cooling Fan Lower is an OEM part for GE wall ovens. This lower fan helps circulate air through the lower cavity compartment to maintain safe internal temperatures.

Symptoms of a bad fan can include:  

• Excessive residual heat buildup in the lower cavity 
• Warm touch temperatures along lower oven exterior
• Fan motor making abnormal noises during operation

Causes usually involve degradation or failure of the electric fan motor from years of sustained use. Physical damage is also possible from accidental impacts. 

This genuine GE part is compatible with Hotpoint, RCA and select Kenmore models as well.

Black. 8-18 AB HXW 3/8

Decorative trim piece for the lower edge of your wall oven where it meets cabinetry. Replace if cracked, damaged, or missing to cover gaps and restore a clean look.

The GE Board Relay Daughter is an OEM part for GE ranges. It enables relay-based electrical control functions for safe operation. 

Causes of a bad board relay can include failures in the circuit components over many power cycles. Moisture or accidental damage could potentially disrupt electrical connections.

Symptoms of a bad board relay include:

• Inability to ignite burners or power oven systems 
• Removal of electricity to relevant relays requires diagnostics
• Loose, arcing or burned connections necessitating replacement

This OEM GE part is also compatible with Hotpoint, RCA and select Kenmore ranges.

Bottom cabinet trim finishes the lower edge of your wall oven cutout. Replaces cracked, damaged, or missing trim to cover gaps and restore a clean appearance.

Fix uneven baking or slow convection cooking. This convection fan motor circulates hot air for consistent heat. Moderate DIY repair restores performance.

Oven won't heat or shut off during self-clean? This high limit switch prevents overheating damage. Common fix after self-clean cycle failures.

Fix a wall oven stuck on broil, unresponsive buttons, or erratic temperature control. This control board manages all cooking functions. Moderate DIY.

Right-side door hinge for wall ovens. Serves as the pivot point for smooth door operation. Replace if cracked, bent, loose, or causing misalignment.

This replacement screw fastens panels, brackets, or trim inside your appliance. Swapping in a new screw restores a tight, secure fit and helps stop rattles, looseness, or misalignment caused by missing or damaged hardware.

• Secures panels, brackets, or trim to the appliance chassis
• Helps maintain proper alignment and spacing of components
• Replaces missing, rusted, or stripped hardware
• Helps resolve loose panels/handles, vibration, or rattling noises

• Disconnect power before servicing; for gas appliances, also shut off the gas supply
• Match the screw to the original location; start threads by hand to avoid cross-threading
• Use the appropriate driver and tighten snugly without overtightening
• Inspect the mounting hole or clip for damage and address as needed before reassembly

Seals the convection fan assembly to prevent air leaks and maintain even heat distribution. Replace if you notice uneven cooking or temperature fluctuations.

Uneven baking or roasting? This oven convection fan blade circulates hot air throughout the cavity for consistent cooking temperatures. Mounts to motor shaft.

Replace your oven's halogen light bulb to restore clear interior visibility while cooking. G9 two-pin base design ensures easy installation.

Replace your wall oven light lens cover to restore visibility inside the oven cavity. Essential when cracked, discolored, or damaged by heat exposure. Verify fit with your model number before ordering.

Left-side door hinge for wall ovens. Supports and guides the door during opening and closing. Replace when hinge is broken, cracked, or worn out.

Positions and cushions the glass inside your oven door assembly. Replace if cracked, compressed, or if glass rattles. Confirm fit with your model number.