Kbf25evms00 Parts

Rubber grommet that cushions and secures the refrigerator condenser assembly. Replace if cracked, worn, or missing to reduce vibration and noise.

Replacement mounting screw for griddles and refrigerators. Secures panels and components. Needed when original screw is missing, stripped, or damaged.

Fix refrigerator power or control issues with this wire harness. Replaces damaged wiring that causes electrical faults or component failures. Direct fit.

Refrigerator not cooling or powering on? This wire jumper bridges terminals to complete electrical circuits between components. Simple 10-minute fix.

Factory screw that fastens refrigerator panels, brackets, and internal assemblies. Replaces missing or worn hardware to restore secure alignment.

This is a heater element installed in or near the upper condensate drain pan of a refrigerator. It warms the pan to help evaporate collected defrost water before it can overflow. Replace this heater if you notice water pooling beneath the refrigerator, water leaking onto shelves or the floor, or if the drain pan is not drying out between defrost cycles.

Replacement door hinge for bottom-mount refrigerators. Restores smooth pivoting and alignment. Replace if cracked, broken, or causing door sag and gaps.

This replacement receiver lens covers and protects the appliance's infrared/receiver area and indicator light while allowing signals and status lights to show through clearly. It restores proper protection and visibility for the sensor/indicator assembly. What it does:

• Protects the IR/receiver and indicator area from dust, spills, and impact
• Allows remote/IR signals and indicator lights to pass through without obstruction
• Replaces cracked, discolored or missing lens that can hide status lights or reduce signal clarity
• Helps maintain original appearance of the control/console area

• Disconnect power to the appliance before beginning any repair.
• Remove the control console or front panel per the service manual to access the lens.
• Handle the lens gently to avoid scratching; seat it into the bezel until it snaps or rests securely.

Self-drilling screw secures panels, brackets, and trim without pre-drilling. Replace missing or stripped screws during appliance repair or reassembly.

Insulates and seals around your refrigerator's air damper to reduce noise, control airflow, and prevent temperature loss. Replace if worn or torn.

Replacement 8-18 thread screw for securing panels, brackets, and trim on appliances. Replace worn, stripped, or missing screws to keep components aligned.

Restores the outer housing on your refrigerator. Replaces a cracked, broken, or missing cover panel. Shields internal components from dust and debris.

This Clamp-Tube secures small appliance tubing and helps maintain a watertight connection so hoses stay in place and reduce leaks or movement. Durable metal construction designed to hold tubing firmly at fittings. What it does:

• Secures water or drain tubing to fittings to prevent disconnection and leaks
• Reduces hose movement and vibration that can cause wear or chafing
• Helps maintain consistent water flow by keeping connections tight
• Common symptom: loose or leaking tubing, rattling or intermittent water flow

• One tube clamp

• Disconnect power and shut off water supply before starting any repair
• Slide clamp over tubing then position at fitting and tighten with pliers; avoid over-tightening
• Inspect tubing and fittings for damage and replace if cracked or worn

Positions and supports the upper edge of your refrigerator door to maintain proper clearance and alignment. Replace if cracked, worn, or missing.

Sealer for refrigerant line insulation.