Kfxs25rymso Parts

This replacement roller pan slide keeps the oven broiler/drawer pan rolling smoothly and aligned for reliable operation. It restores proper pan support and helps prevent binding or uneven movement. What it does:

• Provides a smooth sliding surface and support for the oven broiler/drawer pan
• Replaces worn or broken slides that cause sticking, wobbling, or noisy operation
• Helps keep the pan properly aligned so it inserts and removes easily
• Fits into the existing slide/runner assembly to restore normal function

• One roller pan slide

• Remove power to the appliance and allow any hot surfaces to cool before servicing
• Inspect matching slides and mounting hardware; replace both sides if one side is severely worn
• Simple snap-in or screw-mount replacement on many models;

This part is a replacement electronic control board for a water and ice dispenser on a refrigerator. It is manufactured by Whirlpool. The control board is responsible for facilitating all dispenser operations, including dispensing ice and water, and turning the light on or off. When the user selects an action, a signal is sent to the control board, which then activates the appropriate system.Electronic control boards can last for many years. However, exposure to moisture and general wear and tear of contacts and soldered parts may lead to failure. If the control board has failed, the dispenser will not function, or will function erratically. Replacing the control board will require using a flathead screwdriver to pry off the dispenser cover. Locate the board, disconnect the wires, and remove it. Install the new board by following the steps in reverse.This genuine OEM part is sold individually. It fits Whirlpool brand refrigerators.

This evaporator clip secures the refrigerator evaporator assembly and related components so the cooling system stays aligned and vibration-free. It helps maintain proper airflow and prevents rubbing or loose parts. What it does:

• Holds the evaporator coil/assembly or associated covers in place
• Prevents vibration, noise, and contact between the coil and cabinet parts
• Helps maintain consistent airflow for reliable cooling performance
• Commonly linked to rattling, buzzing, or loose parts around the freezer evaporator

• Disconnect power before servicing the appliance
• Handle evaporator and surrounding fins carefully; they are sharp and fragile
• Verify clip orientation against the OEM diagram before fastening

The Icemaker Fill Cup is an OEM part for Whirlpool bottom-mount and side-by-side refrigerators. Located inside the icemaker assembly, the fill cup sensor works to automatically detect when an ice scoop or bucket is in place below the icemaker chute. It signals the icemaker to drop ice cubes into the receptacle below.

Causes of a bad fill cup sensor can include mineral or dirt build-up inhibiting sensor response, moisture damage to its electronic functioning, or physical damage to the sensor head.

Symptoms of a bad fill cup sensor include:

• Ice failing to dispense or drop when a container is in place
• Ice clumping in the chute instead of dispensing properly  
• The icemaker continuing to run even with ice present below
• Inability to sense when ice is removed from the bucket

This OEM Whirlpool replacement fill cup sensor is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and some Kenmore bottom-mount and side-by-side refrigerators. 

This electronic control module replaces the washer/dryer console's main control and restores cycle selection and electronic features. It manages appliance functions so settings respond correctly and cycles run as commanded. What it does:

• Controls cycle selection, timing and electronic user interface commands
• Interprets sensor inputs to start, advance or end cycles
• Restores normal electronic operation when failed module causes non-responsive controls
• Common symptom: appliance won't start, won't accept settings, or cycles stop unexpectedly

• One electronic control module

• Disconnect power (unplug or shut off breaker) before starting work
• Avoid static discharge; handle the board by its edges and wear anti-static protection if available
• Verify replacement part number matches the original module before installing