Kitchenaid Kucs03ctss0 Trash Compactor Parts

This precision thrust race serves as the hardened bearing surface for axial loads in a rotating mechanism. Replacing a worn race reduces friction and noise, helping restore smooth, consistent motion and protect companion thrust bearings and washers from accelerated wear.

• Provides the hardened bearing surface for a thrust bearing assembly
• Supports axial load and helps maintain proper end-play in the mechanism
• Reduces friction to allow smoother rotation under load
• Wear may present as grinding/scraping noises, rough or binding motion, excessive axial play, or visible scoring

• Disconnect power and shut off water/gas before servicing
• Access the thrust-bearing area; note the order and orientation of races, bearings, and washers for reassembly
• Clean mating surfaces; replace any worn companion parts and lubricate only if specified by the service documentation
• Seat the new race fully and verify free movement by hand before reassembly and testing

Bag carrier handle assembly for trash compactors. Secures the disposable liner bag in place. Replace if cracked, broken, or missing to restore safe bag handling.

Metal mounting bracket that secures internal components in your trash compactor. Replace if bent, damaged, or missing to restore stable part alignment.

Drive sprocket for trash compactor power screw assembly. Replaces worn, broken, or stripped gear that transfers motor power to the drive system.

Drive chain connects the motor to the ram mechanism in your trash compactor. Replace if the chain is broken, stretched, or missing to restore compaction function.

Replacement drawer slide rail for trash compactors. Restores smooth gliding and proper tracking when original is cracked, bent, or worn out.

Replacement leveling wheel for trash compactors and ranges. Installs on the cabinet base to restore smooth rolling and proper leveling adjustment.

This is a right-side metal retainer bracket used to secure the trash compactor in its built-in cabinet opening during installation. It anchors the unit firmly in place to prevent shifting or vibration during compaction cycles. Replace this bracket if it is bent, broken, or missing, which can cause the compactor to move or become unstable during operation.

Left side frame slide for trash compactors. Replaces cracked, broken, or worn slides that support the compactor drawer. Essential structural component.

Door strike plate for trash compactors. Mounts to cabinet frame to secure the door latch. Replace if cracked, bent, or missing to restore proper closure.

Fix excessive noise or wobbling components in your trash compactor with this wave washer retainer. Secures shaft-mounted parts to prevent movement.

Fix a cracked or discolored control panel trim with this escutcheon. Protects buttons and electronics from spills while restoring appearance. Easy install.

This selector switch controls the operating mode of a trash compactor, allowing the user to choose between different compaction cycles. It is mounted on the control panel and connects to the unit's electrical circuit. Replace this switch if the compactor does not respond when you select a cycle, stays stuck in one mode, or fails to turn off properly.

Replace your trash compactor's ram if it's bent, cracked, or damaged. This compression component installs at the top of the unit and directly compacts waste.

This is a stainless steel door handle designed for a trash compactor. It mounts to the front panel of the compactor door and provides the grip used to open and close the unit. Replace this handle if it is cracked, loose, or broken off, making the compactor difficult to operate.

Replacement power screw nut for trash compactors. Mounts on the drive screw mechanism. Order a new nut if yours is stripped, cracked, or worn out.