Kudmo1tjbso Parts

I took the top rack out took off old broken rollers and put the new ones in Read more

I followed Matt's awesome video from AppliancePartsPros.com to build up my "I can do this" reserves. But here's the story leading up to that point... We purchased our Samsung WF419 on a “Black Friday” special November 2009 expecting to get some good years out of the washer/dryer pair. We don’t run more than 2 or 3 loads a week in the washer, so ours has had relatively little use over the beginning of its anticipated and expected long life-cycle. When the “thumping” started on the spin cycle a... Read more

The spray arm itself was fine. The problem was with the plastic parts that held it in place. I had to order an entire replacement spray arm assembly to get the small plastic pin and collar I needed. It took a flashlight and some poking around, but I discovered that the arm is held in place by a small plastic pin that drops into place from above. Here's the fix: Gently bend down the flat plastic tube that carries water to the arm so you can reach the pin and pull it up and out, then drop the... Read more

Ordered a new tube so the flapper valves would be clean and close properly. The old flapper valves had buildup on them and would not divert the water to the upper spinner. The cups would get a soap/food scrap residue that hadn't been cleaned off. Wish I didn't have to buy the entire tube and could just get the flapper valves/assembly separately as the tube was fine, just needed the diverter/flapper valves, but price was pretty good and it arrived in a moderately decent time. Snapped right... Read more

• Won't start

I ordered the Door Switch Kit, along with a few other items. However, the switch kit was all that was needed. Isimply followed the instructions that came with the kit. It was necessary to cut the wires which connected to the wire assembly in the door of the dishwasher. I then connected the pieces from the switch kit and then connected the end pieces to the door. I closed the door, and started up the dishwasher. It worked as well as before. Read more

A bit of searching on the internet narrowed the problem down to either the heating element or the control board. As I am not much of a diagnostician I decided to replace both. Along this same line, I would never have attempted these repairs if it hadn't been for the clear, easy to understand repair videos provided for each part. Further, my decision to do my own repairs was made easier because the prices of the parts was so reasonable. I took my time, reviewed the videos and replaced the... Read more

1. To fix the leaks from around the door, I replaced the upper and lower door seals. These were purchased in a separate transcation, so they are not the parts shown here. The upper door seal worked as intended, but the lower seal would not stay in place on the lower edge of the door during a wash. Therefore I cleaned the grease and detergent off the old seal, and installed using silicone sealer/adhesive. The plastic edge pieces for the lower seal were supplied with the kit, and they installed... Read more

Replaced door lower seal and door gasket. Read more

My appliance repair person helped me find the item numbers and recommended Appliance Parts Pros as reliable and good on price. I placed the order and the items came in a timely manner. Problem solved! I would order from APP again. Read more

Unplug the old twist remove. Push the new one in twist,plug the wires in. Flop around on floor under sink to hook every thing up. Read more

• Will not dispense detergent

Removed 4 screws holding front panel of dishwasher door. Identified defective part. Placed online order from APP.com. Part arrived 2 days later. Removed 2 screws to release part. Removed 2 wires from spade connectors and reattached to new part. Screwed in place. Replaced front panel. Done! And couldn't have been simpler! Read more

Husband replaced them with new parts we purchased from Appliancepartspros.com. Read more

Replaced the worn out pieces Read more