Lat821aae Parts

I first replaced the two drive belts and the motor springs. That didn't fix it although they did need replacing. I then replaced the two bearings and the brake assy. The washer runs like new. If you replace the brake assembly, you should also replace the bearings. It will save a tear down later on. The Maytag repairman wanted $600.00 dollars to do the job. I did it for less than $200.00. Read more

I had a lot of problems removing the spin hub, I had to use an air impact wrench to un screw it even then it was very hard, it did not go easy with the hammer & pipe wrench as shown in the video. It was also very hard to remove the bottom spin bearing I had to cut the bearing retainer with a dremel tool so I could get my puller on it. After I struggled to get it apart The repair went very easy, I used brake spring pliers to remove the springs it worked like a charm. I am very pleased with... Read more

I took the wash basket out of the tub to remove all the sludge and scale that had accumulated over the years. But I did not have a spanner wrench to remove the large nut holding the basket to the center shaft. No problem - I used a hammer and chisel on the ears. But didn't realize it was a LEFT HAND THREAD!! That's when the nut split in two and I had no choice but to purchase another. Long story short, it's back together and the washer doesn't smell anymore. Live and learn... Read more

An easy fix for the most part. I had no idea what I was doing, but glad I bought both upper and lower injectors. Not sure why these are separate parts? Cheap plastic. I did not get the hose clamp because I didn't think I would need it. You probably do, so go ahead and just order it or grab one if you have one laying around. Mine is hooked up without it for now which I'm sure I will regret later but I needed to get our washer running immediately due to a bed bug situation in our house. Read more

• Won't start

Replaced the unbalanced lever assembly - cost about $14. I spent about as much time trying to find the part locally as it took to get the part from appliance pros; I ordered the part at 11:45 am on a Monday and the part was waiting for me by the time I got home from work on Tuesday - thank you. The parts schematics you provided on your website were very helpful. Read more

Water was not draining on spin cycle. Opened front cover and found belt laying on the floor. After further inspection found motor pulley wheel broken. Ordered pulley and belt kit. Replaced pulley along with pump belt and tub belt. Washer is working again. Read more

Removed shaft with slide hammer and inspected the yoke and gearing replaced the shaft and seals with the shaft kit and replaced the tub bearing. 32 years and still running strong Maytag yeah!!!! Doubt the newer ones will run as long thanks for having the parts. Read more

I took the cover off the transmission and determined that the only possible knocking had to be coming from the yoke. I ordered a new yoke and all the tub seals needed to put it back together like new. I also ordered a new drive pulley bearing because this bearing is always turning whenever the washer is used. I cleaned all the parts up while I was waiting for the new parts to arrive. I promised my wife I would make it look like new. I installed all the new parts in one day and let the... Read more

I removed the front cover and saw water a rusted out drum cover clamp. Water gushed out at this point when i operated the machine. I ordered a new clamp and seal from Appliance Parts Pros, which arrived quickly. I wire-brushed the drum and it's cover clean, in the sealing area and installed the new seal and clamp. NOTE do not set the cover down all the way down, or the tub will not "spin". Leave 3/8- 1/2" clearance between the top of the tub and the upper cover. I chose to fix my old... Read more