We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This holder bracket secures internal refrigerator components in place. Replace if your original bracket is cracked, broken, or missing to restore stability.
Originally, replaced the door open/close motor thinking it was failing, but after a while ice chute door started to not fully open again. That left only two other failure modes - - signal pulse duration from control board, or the convoluted plastic link, lever, and cap assembly shaft binding/bending. Replaced them all. Since then operating correctly - - no further issues. It is possible the plastic levers and/or door cap shaft was binding, or bending, not allowing the cap to fully open. For... Read more
Most orders arrive by Wednesday, November 25
This fan grille assembly covers and protects the refrigerator's fan while channeling airflow through the vents. Replacing a cracked or missing grille helps restore proper air circulation and can reduce noise and temperature fluctuations.
The part was easy to install in less than 30 minutes. The part came within two days and I watched the video twice. I followed the instruction step by step. Thanks. Read more
Fix a refrigerator not cooling properly with this compressor sealing pipe. Essential sealed system component for restoring proper refrigeration.
I changed the compressor, dryer and upgraded the software. Read more
Covers and protects the internal fan while directing airflow through the refrigerator cabinet. Replace if cracked, broken, or missing to restore proper air circulation.
Fix loud jackhammer sounds or weak water flow from your refrigerator dispenser. This filter head assembly houses the water filter inside the fridge.
Secures internal components in place to prevent rattling and misalignment. Replace if cracked, broken, or missing. Confirm fit with your model number.
Water pooling under your dispenser? This drip tray catches overflow and spills. Cracked or stained trays are easy to replace with basic tools.
Removed water dispenser housing using thin point kitchen knife insert knife at lower left side of housing twist knife and grab housing with finger nails carefully pulling as you move further along housing .the rest was pretty much easy, use small star screwdriver to remove micro switch.new switch is a little different.upon replacing housing start at the bottom up the sides to the top press firmly until you hear housing snap in tight Read more
Supports and guides refrigerator drawers for smooth gliding. Replace when worn, broken, or causing binding. Confirm fit with your model number.
Replaced. Read more
Refrigerator not cooling properly? This air duct and evaporator cover with fan circulates cold air throughout your fridge. Moderate DIY repair.
Air Duct fixed the reftig. The defroster & control fixed freezer. Thanks for the help and great parts. LFX31925ST/00 Always remember the /00 to get the correct part. Thanks Tom Read more
Mounts at the hinge to control door opening range and promote smooth closing. Replace if cracked, broken, or worn to restore proper door swing.
Replacing the door hinge and stopper assembly was very easy, once I figured out you had to disconnect the water supply on the back of the fridge before removing the door. Read more
This holder assembly is a structural mounting piece that supports and secures an internal component in your appliance. Replacing a cracked or worn bracket helps restore proper alignment and keeps parts stable during everyday use.
Installed new screws. Read more
Door hinge screws secure the refrigerator door hinges to the cabinet frame, allowing proper door operation and alignment. Replace when doors sag, don't close properly, or screws are loose, stripped, or missing causing door misalignment.
Replacement screw for securing panels, brackets, and internal components. Restores tight fit and proper alignment when original hardware is stripped or missing.
Disassembled and replaced ac motor. The hardest part was to pull the microwave out of the cabinet. Read more
Vibration-isolating grommet that mounts between the compressor and chassis. Replace if cracked, worn, or missing to restore proper cushioning.