Lse806aee Parts

Secures and supports your range oven door hinge for proper alignment and smooth operation. Replace if bracket is cracked, bent, or damaged to restore door fit.

Replaces the rear cabinet panel on your electric range. Shields internal wiring and components from dust and damage. Order a new panel if cracked or missing.

Decorative trim piece that surrounds the rear of your range for a finished look. Replace if cracked, chipped, damaged, or missing. Enamel finish.

Replace your range's vent grille if cracked, broken, or missing. This cover piece installs over the ventilation opening on your electric range. Restores appearance.

This sheath heater is the heating element assembly that warms air inside the dryer to remove moisture from clothes. Replaces a worn or failed heater to restore normal drying performance. What it does:

• Generates heat for the dryer's air flow so loads dry efficiently
• Commonly linked to symptoms such as no heat, cool air from the dryer, or significantly longer dry cycles
• Works with the dryer's blower and thermostat system to maintain drying temperature
• Should be tested alongside thermal fuses and thermostats when diagnosing heating problems

• One sheath heater assembly

• Disconnect all power to the appliance before beginning any repair
• Handle the heater element carefully to avoid bending or damaging the sheath
• Inspect and test associated components (thermal fuses, thermostats, wiring) for faults during replacement

This heater working coil is the heating element coil used to generate heat for clothes drying. It restores the dryer's ability to produce consistent heat so cycles can properly dry laundry. What it does:

• Converts electrical energy into heat for the dryer's drum air flow
• Restores normal drying performance when a broken coil causes little or no heat
• Helps prevent long dry times and reduces repeated cycle runs due to insufficient heat
• Can be part of the repair when heating is intermittent or shuts off during a cycle

• Disconnect power to the appliance before starting any repair; verify the unit is fully de-energized
• Allow the dryer to cool and remove panels as needed to access the heater assembly
• Handle the coil and terminals carefully to avoid damage; ensure proper routing and secure fasteners on reassembly
• Check fuses/thermal cutoffs and wiring for additional faults

Main cabinet housing for ranges. Replaces damaged, dented, or cracked outer cabinet. Supports internal components and restores structural integrity.

Insulator for electric and gas ranges. Replaces cracked, broken, or missing insulation components. Restores proper heat protection and spacing.

Insulator for electric and gas ranges. Installs between internal components to provide heat or electrical protection. Replace if cracked or missing.

Insulation component that protects internal range wiring and components from heat. Replace if cracked, deteriorated, or missing to restore proper insulation.

Replace your range's control panel if the original is cracked, damaged, or has faded graphics. This panel mounts to the front of your appliance housing.

Restores your range's appearance and protects control buttons from spills and debris. Replace when cracked, discolored, or damaged. Confirm fit with your model.

Outer trim panel that covers and protects the control area. Replace if cracked, scratched, discolored, or damaged to restore a clean, finished appearance.

Base plate for electric and gas ranges. Provides structural support at the bottom of the appliance. Replace if cracked, broken, or missing. Easy install.

Support bracket that secures the control board assembly inside your range. Replace if the bracket is cracked, bent, or missing to properly mount the PCB.