We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This mixing valve blends hot and cold supply water to reach the selected temperature during fill. Replacing a worn valve restores correct water temperature and flow so cycles run as intended. What it does:
Replaced mixing valve. Very easy job. Read more
This spline insert is the small splined bushing that fits onto a drive shaft to transfer rotational force between the motor/shaft and the driven part. It restores a secure, slip-free connection for proper appliance operation. What it does:
This was a very easy fix. Two screws to get the front off of the washer. Removed one side of the tensioner spring. Loosened two screws for the motor and two screws for the pump. I decided to replace the agitate belt even though it wasn't broken.. So, I removed that belt from the pulleys and the removed the broken belt. then just reversed the process to install the belts. it toke me less than 30 minutes and my washer was back in service. Read more
The water inlet mixing valve controls the flow and temperature of water entering the washer by blending hot and cold water supplies. Located at the back of the machine where water lines connect, it responds to temperature selection commands. Replace if water temperature is incorrect, no water enters the tub, or leaking occurs at the valve connections.
Attaches directly to the motor.
My wife found soapy water on the floor of the laundry room. I removed the front access cover on the washer and found water in the bottom of the washer and seeping our the drain holes. Running a rinse and spin cycle showed water leaking out of the pump all the time there was water in the tub. I ordered this pump and after watching a youtube video of someone else doing it had no trouble installing it. Problem fixed. You do need a torx head screw driver T20 or T25 to remove the pump from the motor. Read more
2-port.