Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Fix loose or rattling parts with this 1/4-20 nut. Secures components in dryers, washers, and microwaves. Quick 5-minute repair restores stability.
After watching the repair video I opened up the dryer without any problems and found that the belt tension pully bearing failed and the mount arm had an excessive amount play in it. So armed with the part numbers I found here I went down to the local parts store and found that they did not stock the parts but could get them in a week. I went home and ordered them on line and had them the next day. I did vary from the video a bit. I uncliped the motor wire connector and removed the two screws... Read more
Usually ships within 4 - 14 days
Washer not cleaning clothes properly or agitator won't move? This short agitator replacement restores proper wash action. DIY-friendly repair.
Restores proper tension to the idler pulley assembly for smooth drum rotation and quiet operation. Replace if worn or broken to prevent belt slippage.
The video on the site on how to replace the belt on the washer was great! The key to get the right belt is to check the model AND the MFG number. Otherwise you may get the wrong belt like I did. However, AppliancePartsPros was great and credited me for the first belt and then shipped the correct belt within 2 days. The video was great and the service was first rate! Thank you! Read more
Terminal extract tool for dryers and washers. Used to safely remove electrical terminals from connectors during repairs. Essential when replacing wiring.
Filters debris and sediment from incoming water before it reaches the inlet valve. Replace if clogged or missing to restore proper fill flow. Confirm fit.
The machine would not run a full cycle before it cut off and had the code "FE" and water was too high. The water inlet valve needed to be replaced since it was letting in too much water at time. The repair was easy. Unplug machine and turn off cold water. Remove cold water line and drain water into bucket. Remove back two braces located at the top on each end of machine This will allow you to move top cove back about one inch. Pull back top cover about 1 inch then lift off cover. Remove... Read more
This mixing valve blends hot and cold supply water to reach the selected temperature during fill. Replacing a worn valve restores correct water temperature and flow so cycles run as intended. What it does:
Replaced mixing valve. Very easy job. Read more
The water inlet mixing valve controls the flow and temperature of water entering the washer by blending hot and cold water supplies. Located at the back of the machine where water lines connect, it responds to temperature selection commands. Replace if water temperature is incorrect, no water enters the tub, or leaking occurs at the valve connections.
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.