Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Front load washer door boot seal, comes with drain plug and clamp.
I used the instructions from some of your previous customers. When I was ready to pull the inner tub from the outer tub, it pulled very hard. The front bearing had been HOT and really marked the shaft. The SEAL appeared to be almost plastic, not much left. I removed the seal from the Front bearing. This model had the original type seal with the plastic spacer behind the seal and in front of the front bearing.. BE SURE TO NOTE HOW THE PLASTIC SPACER CAME OUT--feet on spacer toward the... Read more
Busted unit open, found leaks, ordered parts. Cleaned out the mess, put new parts in, works like a champ! Easy as it can get! Read more
Ordered the part and fixed it myself Read more
Ordered the parts, watched the video and went to work on both. It was all very easy! Read more
This is a Whirlpool washer drive motor and control board. The drive motor and motor control board are responsible for the spin cycles of the washer. A faulty motor may show signs of malfunction through a slower than average spin cycle. When the control board shorts out, the washer typically will not spin at all.Begin installation by removing the body of the washer. There are two screws at the base of the console. Remove these screws and flip the console back. Two clips are holding the body in place. Remove them with a flat-head screwdriver. Push these clips and pull the body off the washer. Now that the motor is exposed, remove the screws holding the motor in place with a nut driver. Two more clips fasten the motor. Push these clips with the flat head, and the motor is free to remove. Unplug the control board's wire harness from the washer. The new component is ready for install after these steps.The part is sourced directly from the manufacturer as a genuine OEM product. This kit is sold separately from the washer. This product is compatible with Whirlpool, Maytag, and Admiral appliances.
I had watched some videos on youtube to understand how to disassemble & gain access to the various washer components & their location. Very easy. I had first replaced the wax motor, but that was not the problem. I reviewed the diagnostic procedures that were present near the control board, followed the directions to remove the main plug from the motor control board, which should allow the washer to spin at 50 rpm. No spin, & upon closer inspection, I observed that one of the phase drive... Read more
Ordered new baffle and the proper screws with help from appliance parts pros. Took washer apart. Removed soap dispenser cover, washer door, front, lifted top lid, removed seal to be able to access area to get screws in and tightened with a wrench. This part wasn't the easiest as there wasn't much room for my hand(s) to fit in, but just took my time and got it done. Read more
This Is A Set Of Two Struts.