Maytag Dg710 Parts

Replaced the control board after removing the inner door liner, plastice board cover and board itself, by removing screws, working various plastic clips/tabs and unclipping wire harnesses from board. most of time was spent cleaning the black soot from the door, which had a terrible burnt electrical/plastic fire smell. Cleaned mold/scale off of as much of the door as I could while in there as well. Removing parts without breaking plastic tabs to hold the new parts was trickiest part. Read more

Weekend laundry became very noisy, our 1987 Whirlpool washer began doing a dance across the floor and the drum was banging into the inner cabinet. After doing some research and watching a few videos on Appliance parts pros website. I inspected the washer and noticed one leg the rubber coating disintegrated, decided to change all four legs, springs and lid switch. Hardest part of the job is getting the cabinet together. Ops check good. Read more

I ohm metered the sensors to determine which one was bad (open) Looked up the part on the parts drawing. Ordered part and had the dryer running 2 days later Read more

I ordered a new heating element and two other parts that attached to the heating element. I discovered a wire that broke off which caused the element not to work so I had to put a new female splicer on the broken wire then replaced the element and reattached the wires and everything worked. Read more

Replaced switch assembly Read more

In the past, I replaced some electronic components on our gas dryer, the solenoid and the electronic ignitor, but the rest of the dryer looked more difficult to repair if needed in the future. I was wrong. I went unto AppliancePartsPros.com and watched some repair videos on dryers like mine that make big thumping sounds while drying. This happened when I googled my dryer model number in an attempt to find out is capacity, because I wanted our new dryer to have the same capacity. I found out... Read more

Took the front panel off (the door front), disconnected the connector to the door switch and used a wooden clothespin to bypass the door switch. Turned on the dryer to locate loud squeaking sound and found it was coming from the motor area. When I started to take the blower section apart from the motor, that is when I saw the "blower wheel" slipped off the motor shaft. The blower wheel has a "C" clip retainer and compression ring to keep it snug on the motor shaft (but it was loose). Now I... Read more

Replaced with new Drum Baffles Read more

We fixed it ourselves, very easy. Read more

At first i just bought the belt, started dryer and off came the belt, and yes it was in place,looking at the idler arm it had a lot off back and forth movement so i ordered the whole assembly but the spring which no one has.put it all together again but drum barely turned.. so back apart and belt was in place. took the idler spring out cut 4 loops off it re did the end so it would hook on idler arm.and that did the trick.runs like new. Read more

I found the Appliance Parts Pros website and WOW! I am very grateful that I found the website! I called the phone number on the website and there was a woman who took my call and was extremely helpful with helping me determine an optimal course of action. She advised that I follow the video that was on the website to verify that I needed a dryer belt. This had been my assumption up until the time I had spoken with her. but I was not basing my assumption base on seeing that I needed a new dryer... Read more