Maytag Dg710 Parts

Problem was solenoid (coil) not allowing gas flow for re-ignite. Since there are 3 coils in this Maytag dryer, all 3 should be replaced at the same time. The Maytag model number is HDG-308. However, the search for parts does not recognize the "H". Thanks Appliance Parts Pros customer service for confirming that this was the correct kit before shipment. Parts arrived in 2 days with standard shipping. Follow the directions supplied with the kit and you should have no problem with this easy... Read more

• Shuts off too soon
• Doesn't shut off

My dryer is twenty years old could not believe appliance pros still had the part. Shipping was speedy and ordering was easy off the web site. Read more

Took the front panel off (the door front), disconnected the connector to the door switch and used a wooden clothespin to bypass the door switch. Turned on the dryer to locate loud squeaking sound and found it was coming from the motor area. When I started to take the blower section apart from the motor, that is when I saw the "blower wheel" slipped off the motor shaft. The blower wheel has a "C" clip retainer and compression ring to keep it snug on the motor shaft (but it was loose). Now I... Read more

I removed the single screw that held the existing lens in place and removed the lens. I then used an awl to properly line up the new lens in place, since it is in an inconvenient spot inside the dryer drum. Then I taped the lens in place temporarily with blue tape, removed the awl and re-installed the screw and tightened it securely. I finished the job by removing the blue tape. More seriously, over the years I've used appliance parts pros to order repair parts for my dishwasher, my... Read more

I replaced this solenoid gas valve coil after testing it for continuity. It worked! Read more

This was a Maytag DE312 actually a Whirlpool labeled as Maytag) and is 27 years old. Replaced motor, drive belt and drum rollers. One tricky part was the motor because the new motor comes with integral starter and it was necessary to cut off existing female spade connectors on some wires and crimp on new connectors. Instructions were adequate but need to be carefully followed and a decent electrical stripping and crimping tool must be at hand. I bought a new motor drive pulley because another... Read more