Md2300 Parts

Note: For faucet adapter

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

Size: 8-32 x 1/2 inch.

This pump gasket seals the connection between the appliance pump and housing to help prevent leaks and keep water flowing where it should. A simple replacement that restores a watertight pump interface. What it does:

• Creates a tight seal at the pump housing to stop water from leaking
• Helps maintain proper drain flow by preventing bypass leaks
• Commonly replaced when you see puddling or moisture under the appliance
• Can prevent intermittent draining issues caused by a compromised seal

• One pump gasket

• Disconnect power and water supply before starting any repair
• Inspect mating surfaces and clean debris before installing the new gasket
• Ensure the gasket seats fully and pump/housing fasteners are torqued to spec

This O-ring is a small rubber sealing gasket that prevents water leaks at a refrigerator water connection. It restores a watertight seal to stop drips and maintain proper water flow to the dispenser/ice system. What it does:

• Creates a watertight seal at a water line or valve connection
• Helps stop visible dripping or slow leaks from fittings
• Maintains proper pressure and flow by preventing bypass around a joint
• Used where a compressible seal is required between two mating parts

• Shut off water supply and disconnect power before servicing
• Replace only with the correct-size O-ring and seat it evenly in the groove
• Inspect mating surfaces for nicks or debris; clean before installing the new O-ring
• Tighten fittings to manufacturer torque recommendations to avoid over-compression

This wash impeller is the pump rotor that moves dishwasher wash water through the circulation system to help clean dishes. Replacing a worn impeller restores proper water flow and improves cleaning performance. What it does:

• Spins on the wash pump shaft to push water through spray arms for effective cleaning
• Helps maintain proper spray pressure during the wash cycle
• Worn or damaged impeller can cause weak spray, poor cleaning, or unusual pump noise
• Works with the pump housing and seals to keep water circulating where it belongs

• One wash impeller

• Disconnect power and water supply before beginning any repairs
• Access the lower pump assembly by removing the lower access panel and spray arm(s)
• Inspect pump housing and seals; replace any damaged gaskets to prevent leaks
• Reassemble carefully and run a test cycle to check for proper operation and leaks