Mde8100dw Parts

The seal had popped off of the plastic gasket, and due to the blower fan blades and the heat, it was not able to fit properly back on the unit. After spending a week researching new dryers (I was ready to drop the credit card down...) I pulled the unit apart and found the issue with the seal. After receiving the new part, it took me about 15 minutes to put the new one on... its a little tricky if you don't take the whole front apart. After replacing the seal, the blower was able to suck air... Read more

Ordered the clip and put it back on. 10 min job Read more

I figured it had to be the flume; changed the flume and hose, mounting screws Read more

Busted unit open, found leaks, ordered parts. Cleaned out the mess, put new parts in, works like a champ! Easy as it can get! Read more

Replaced inner door panel Read more

Disassembled the back cover, unplugged the touchscreen control panel, removed the front panel, and finally removed the top panel to access the exterior of the drum. I removed the old screws & installed the new baffles to the drum, then reassembled everything. Read more

First, replaced the bad door switch still won't start. Then, check the circuit breaker to the dryer found this too is bad. Replaced circuit breaker. Problem solved. Read more

New felt, back and front. DID NOT NEED THE HIGH TEMP ADHESIVE for this model. Cleaned inside thoroughly. Read more

After checking all the common reasons (vent, element, fuses, temp sensors, etc.), the only thing left was the Dryness Monitor. The "LESS" light came on, but the ""HIGH" light didn't. Removed the 5 screws on the rear cover, disconnected the 4 wire & single wire plugs and the unit just snaps out. Since my dryer is Almond colored and the part was for a White dryer, I took the one screw out holding the board and transferred it to the original housing. Reconnected the 4 wire & single wire plugs and... Read more