Medb202 Parts

Screw for control panel.

Self-drilling screw secures panels, brackets, and trim without pre-drilling. Replace missing or stripped screws during appliance repair or reassembly.

Front bulkhead assembly centers your dryer drum and mounts the bearing and seal. Replace if corroded, warped, or damaged to restore alignment and reduce noise.

Dryer won't start or shows F-02 error? The control board processes settings and start commands. Test door switch and thermal fuse first, then replace board.

Dryer Vent Test Kit ensures your dryer's vent system is operating properly. Kit includes two tests depending on the location of your dryer's lint screen: One for the lint screen in the top of your dryer, and one for the lint screen in the front of your dryer. Instructions included.

Secures the lint filter duct to the dryer blower housing. Replace if the clip is broken, cracked, or missing to properly hold the duct in place.

Replaces a cracked, broken, or missing dryer drum baffle. This interior drum component helps tumble clothes during the drying cycle.

Seals the gap between the dryer bulkhead and front panel around the door opening. Replace if torn, deformed, or causing air leaks. Confirm fit by model.

Fixes dryer that won't start when button is pressed or runs without door closed. Restores reliable circuit control for start, stop, and safety functions.

Foam seal creates an airtight joint between blower housing and cover. Replace if crushed or torn to restore airflow and prevent heat loss. Confirm fit.

This motor connector housing is the molded body that holds the motor's wire terminals for a secure, insulated connection. Replacing a cracked or heat-damaged housing helps restore reliable motor operation and prevent intermittent power issues.

• Organizes and insulates the motor's wiring terminals
• Locks the harness to the motor for a firm electrical connection
• Helps reduce loose contacts, arcing, and heat damage at the plug
• If the housing is failing, you may see intermittent or no motor operation, the machine stopping mid-cycle, or visible melting/discoloration at the motor connector

• Disconnect power; also shut off gas supply
• Note wire positions; transfer terminals into the new housing one at a time to maintain orientation
• Inspect terminals and wiring; replace any burnt or loose terminals before reassembly
• Ensure the connector seats fully on the motor and the harness is secure; restore power and test

Motor drive pulley for dryer drum belt. Installs on motor shaft to transfer power and spin the drum. Replace if worn, cracked, or causing belt slippage.