Medb850wl Parts

Fix uneven steam distribution or wrinkles not smoothing out with this steam spray nozzle. Restores proper steam flow when clogged or cracked. DIY repair.

This is a Y-shaped hose connector fitting used to join or split water supply lines. It allows two hoses to connect to a single water source or directs water flow between components. Replace this connector if it is cracked, corroded, or leaking at the connection points.

Replace your cracked or missing dryer drum baffle to restore proper tumbling action. This lifter bar attaches inside the drum to lift and separate clothes.

Secures the lint filter duct to the dryer blower housing. Replace if the clip is broken, cracked, or missing to properly hold the duct in place.

Retainer clip secures interior panels and trim in your dryer, reducing vibration and rattling. Replace when panels feel loose or fasteners break.

Replacement door hinge for your dryer. Mounts between the door and cabinet to allow smooth opening and closing. Needed when hinge is cracked or broken.

Dryer lint screen door provides access to the lint filter. Replace if cracked, broken, or won't close properly. Verify fit with your model number.

Fixes dryer that won't start when button is pressed or runs without door closed. Restores reliable circuit control for start, stop, and safety functions.

Restores proper tension to your dryer's lint screen door for smooth opening and closing. Replace if the cover is loose or won't stay closed securely.

Foam seal creates an airtight joint between blower housing and cover. Replace if crushed or torn to restore airflow and prevent heat loss. Confirm fit.

This motor connector housing is the molded body that holds the motor's wire terminals for a secure, insulated connection. Replacing a cracked or heat-damaged housing helps restore reliable motor operation and prevent intermittent power issues.

• Organizes and insulates the motor's wiring terminals
• Locks the harness to the motor for a firm electrical connection
• Helps reduce loose contacts, arcing, and heat damage at the plug
• If the housing is failing, you may see intermittent or no motor operation, the machine stopping mid-cycle, or visible melting/discoloration at the motor connector

• Disconnect power; also shut off gas supply
• Note wire positions; transfer terminals into the new housing one at a time to maintain orientation
• Inspect terminals and wiring; replace any burnt or loose terminals before reassembly
• Ensure the connector seats fully on the motor and the harness is secure; restore power and test

If assemblies shift or rattle during dryer operation, this snap-down locator clip secures components in place. Simple snap-in installation restores alignment.

Motor drive pulley for dryer drum belt. Installs on motor shaft to transfer power and spin the drum. Replace if worn, cracked, or causing belt slippage.

Front bulkhead assembly centers your dryer drum and mounts the bearing and seal. Replace if corroded, warped, or damaged to restore alignment and reduce noise.