Mhwz600te Parts

Replace your washer's control panel if it's cracked, damaged, or has missing components. This panel covers the control area and maintains appearance.

Replacement door handle for your front-load washer. Installs on the outer door assembly. Order a new handle if yours is cracked, broken, or loose.

Cable retainer for washers. Secures and holds cables in place during operation. Replace if cracked, broken, or missing to properly support wiring.

Nameplate badge assembly for washers and dryers. Installs on the control panel or cabinet front. Replace if cracked, faded, peeling, or missing.

This water level pressure switch senses air pressure from the tub and signals the control to stop filling at the correct level. Replacing a weak or failed switch restores proper filling, helps prevent over/underfilling, and allows cycles to advance.

• Monitors tub water level via the pressure hose and sends the level signal to the control
• Stops water flow at the target level so wash, rinse, and spin can begin
• Common symptoms of a failing switch: continuous filling, overfilling or underfilling, cycle won't advance past fill/sensing, or stops with water still in the tub
• A cracked, kinked, or blocked pressure hose can mimic switch failure—inspect during diagnosis

• Disconnect power and turn off water supply before servicing
• Access the switch from the console/top or rear panel per your model; note wire orientation
• Transfer and firmly seat the pressure hose; inspect it for kinks, cracks, or blockages and replace if damaged
• After installation, run a fill test; some models may require a diagnostic calibration—see the tech sheet or user manual

This drawer hook is the retainer that keeps an appliance drawer securely seated while still allowing easy release for cleaning or service. Replacing a worn or broken hook restores smooth, reliable drawer operation.

• Secures the drawer in its housing so it stays closed during use
• Acts as the catch/release point for removing the drawer when needed
• Helps maintain proper alignment for smooth opening and closing
• Common symptoms: drawer won't stay closed, pops open or falls out, won't latch, or the hook is visibly cracked/missing

• Disconnect power before servicing
• Fully open and remove the drawer to access the hook area
• Align the new hook with the slots/tabs and snap or seat it into place
• Avoid forcing components; refer to the service manual for model-specific steps