Ml-Em45pit Parts

Pop rivet secures sheet-metal panels, brackets, and burner jar lids on appliances. Replace missing, drilled-out, or damaged rivets for permanent hold.

Size: 10-24 x 3/8 inch.

Dryer won't start or runs intermittently? A worn door switch actuator may prevent the microswitch from engaging. This assembly restores proper operation.

Washer won't spin or stops mid-cycle? This tub displacement switch senses water level and balance to restore proper spin operation. DIY-friendly fix.

Rubber gasket that seals the joint between the tub and cover to prevent leaks and water seepage. Replace if you notice leaking or debris buildup. Verify fit.

Dryer won't heat or start? A faulty gas valve assembly that controls gas flow to the burner is often the cause. Direct-fit part for gas dryers.

Dryer won't start or respond to controls? This electronic control board manages cycle timing and user settings. Restores normal operation when failed.

Dryer not heating properly or overheating? This cycling thermostat regulates temperature by cycling the heating element on and off. Moderate DIY repair.

Push-in nut secures counterweights, panels, and trim to washer tub studs. Replace when cracked, stripped, or missing to eliminate rattling.

Replacement screw that secures panels and internal components in your laundry center. Needed when original fastener is missing, stripped, or corroded.

Dryer won't start or stops mid-cycle? This door lock assembly secures the door and engages the safety interlock. Straightforward DIY repair.

This bolt-style retaining screw secures appliance panels and components to prevent movement and rattling. A small but critical fastener that restores proper fit and reduces noise from loose parts. What it does:

• Fastens and secures panels, brackets, or assemblies in place
• Stops rattling or vibration caused by a missing or loose screw
• Restores proper alignment of the attached component
• Matches OEM fit and thread pattern for a secure hold

• Disconnect power and unplug the appliance before beginning any work
• Use the correct screwdriver or socket to avoid stripping the head
• Thread carefully and do not overtighten to prevent damage to threads or plastic parts
• Keep small parts away from children and work on a clean, well-lit surface

Fix a dryer that won't heat or has a weak flame with this gas burner orifice. Controls proper fuel flow for consistent heating. Direct replacement part.

Specs: 7/32 INCH

This mechanical timer controls the dryer's cycle timing and advances the selected program so loads dry on schedule. It replaces a failing timer to restore cycle selection and timed operation. What it does:

• Rotates to advance dryer cycles and engage the correct timed functions.
• Directs power to timer-controlled components during each cycle step.
• Commonly used when the dryer won't advance through cycles or won't run on a timed setting.
• Corrects intermittent or non-responsive cycle selection caused by a faulty timer.

• One timer assembly.

• Disconnect power to the appliance before beginning any work.
• Access typically requires removing the control panel or console; handle internal parts and connectors carefully.
• Tighten fasteners and re-check cycle selection after installation; do not force connectors.

This terminal cover protects and conceals the appliance's electrical wire terminals for safer handling and cleaner internal appearance. It helps reduce accidental contact with live connections and keeps wiring organized. What it does:

• Covers exposed wire terminals to help prevent accidental contact and shorting
• Keeps wiring routed and held in place for improved serviceability
• Protects terminals from dust and debris that can affect connections
• Supports safer access during diagnostics and repairs

• One terminal cover, as shown

• Disconnect power to the appliance before attempting any service
• Remove outer panels as needed to access the terminal area; use manufacturer service guide for panel removal steps
• Align cover over the terminal block and secure per factory mounting points; do not force or modify
• If terminals or wiring appear damaged or corroded, replace or repair those components before reinstalling the cover