Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Found a service manual that is close enough to my GE dishwasher. Service Manual for GE Dishwasher-EDW4000 was found on the following webpage. http://www.applianceaid.com/pdf/serv-man-EDW4000.pdf Gives enough information to test out the dishwasher. Read it, check out Factory Test Mode. GE should have given this out as a normal User Manual. The usual user manual lack anything to help troubleshoot a problem. Read more
Color: white. Measures about 1 inch wide by 1-1/2 inches deep.
Replaced retainer clips. Read more
This mounting bracket secures the dishwasher rinse module/dispenser assembly so the dispenser stays properly positioned for reliable rinse-aid delivery. A correctly seated bracket helps prevent dispenser misalignment and related rinse-aid issues. What it does:
Rinse aid was not dispensing properly. so replacing the dispenser fixed the problem. Very easy to do with the replacement part, although the repair video was not exactly accurate; it was actually easier. Remove the screws holding the door liner and lift it off, and the part is right in front of you. 6 screws off, remember what color wire goes where, reassemble, and you're done. Problem gone. As usual, Appliance Parts Pros is the absolute best source. Read more
Simple 30 sec and $7 fix Read more
This is a genuine OEM replacement lower spray arm bearing sourced directly from the manufacturer for use in dishwashers. The lower spray arm spins to distribute water to the dishes during the wash cycle. Thus spray arm bearing supports the spray arm and lessens the friction, which allows it to spin more easily. If the dishes are not clean after the wash and rinse cycle, or the arm is making loud noises, the spin arm bearing may need to be replaced. This bearing is a small metal part that may wear over time. If the bearing is distorted or damaged, the arm will not sit level, and spinning may be very loud, or it may not spin. The spray arm bearing should be replaced. Turn off the breaker or disconnect the power to the dishwasher. Open the dishwasher and pull the bottom rack out. Turn the lower spray arm counterclockwise to remove it. Use a telescoping magnet to pull the bearing up from the hole in the middle. Install the new bearing and reinstall the spray arm. Put the dishrack back inside and reconnect the power.This lower spray arm bearing is a gray metal part that is sold individually. It is designed for use in dishwashers designed by General Electric and Hotpoint.
The main conduit was broken and the pump connector had a hole in it. The pump also was showing signs of leaking. I completely disassembled the dishwasher cleaned everything and reassembled. The repair videos are a big help. Thank you. Read more
Replaced all the related parts. Read more
I found the manufacturers parts drawing and purchased the parts that were needed.The previous home owner had not only removed from he parts but he had also reversed the direction of the dish rack. The only way I was able to repair it was to figure out how it must function,the rest was easy. Read more
The video provided by Appliance Parts Pros is excellent! I followed its steps. The one problem I had was getting the ribbon to disconnect. The plastic pieces that hold it together are fragile and broke. So, instead of disconnecting the ribbon I placed a kitchen stool in front of the dishwasher door and laid the top portion on it. Then I was able to remove the handle and change out the actuator. The handle was fine and did not need replacing; a tab on the actuator had broken. (In my opinion... Read more
Ordered parts and watched video. It was not the exact same GE as my model. Had to guess at times. Took a couple of hours, but the repair was great. Read more
Fairly close to how the video explained it although had to remove the front door panel completely to remove the operations panel. My dishwasher was a slightly different configuration than shown. Much easier fix than I initially thought it would be though. Read more