Pdw8900l Parts

Lower rack assembly that slides into the bottom of your dishwasher to hold dishes during wash cycles. Replace if cracked, broken, or wheels are worn.

Replacement silverware basket for your dishwasher. Organizes utensils during wash cycles. Order if your original basket is cracked, melted, or broken.

Secures the dishwasher sump connection at the tub base for a leak-resistant seal. Replace if weakened or corroded to stop drips. Confirm fit with model.

This rubber seal connects the dishwasher's wash pump motor to the tub assembly. Replace if you notice water leaking from beneath the dishwasher or around the pump motor area.

Replaces a cracked, broken, or missing water inlet valve trim cover on your dishwasher. Conceals and protects the inlet valve and hose connections.

Fix a dishwasher door that won't stay closed or pops open. This keeper latch assembly catches the door lock to restore proper sealing. Quick snap-in fix.

Covers the gap beneath your dishwasher front. Installs at floor level. Replace if missing, cracked, rusted, or damaged for a complete look.

This mounting nut secures the tower heater assembly in the appliance, keeping the heater stable and properly positioned for safe, efficient operation. Replacing a damaged nut restores secure attachment and reduces rattling or loose components. What it does

• Secures the tower heater assembly to the appliance chassis or mounting bracket
• Helps maintain proper heater alignment for reliable heating performance
• Prevents movement that can cause noise, intermittent contacts, or wear on connections
• Used when the original nut is stripped, corroded, or missing

• One tower heater assembly mounting nut

• Disconnect power to the appliance before attempting any repair
• Use appropriate hand tools; avoid over-tightening which can strip threads or damage the heater assembly

Rubber grommet cushions and seals dishwasher components. Replaces worn, torn, or missing grommets to restore proper fit and reduce vibration noise.

This vent flapper is the exterior exhaust flap that opens to let dryer air and lint exit and closes to keep weather, pests and drafts out when the dryer is off. It restores proper airflow at the outside vent hood. What it does:

• Opens with dryer airflow to allow exhaust to escape and closes when idle to block outside air.
• Helps prevent backdrafts, pests and rain from entering the vent system.
• Can restore normal drying performance when a stuck or broken flap was restricting airflow.
• Commonly replaced when the flap is cracked, warped, jammed or does not seal.

• One vent flapper/exterior exhaust flap.

• Disconnect power to the dryer (and gas supply if applicable) and work from the outside hood when possible.
• Remove the exterior vent hood or access cover to inspect and replace the flap; basic hand tools required.
• Check that the flap moves freely after installation and seats against its seal to prevent air leaks.
• Clean or repair the ductwork to avoid repeat failures.

Sump plate that mounts at the bottom of the dishwasher tub assembly. Replace if cracked, warped, or damaged to restore proper structural support.

This lever assembly allows the upper dish rack to be adjusted for height, located on the right side of the dishwasher rack. Replace when the rack won't adjust properly, feels loose, or the lever mechanism is broken or missing.

Dishwasher mounting screw used to secure internal components and panels. Replace if screw is stripped, missing, or damaged during appliance repair.

This is a small flapper valve located in the dishwasher vent assembly that opens to release steam and hot air during the drying cycle. It closes during wash cycles to prevent water from escaping. Replace this flapper if dishes are not drying properly, if you notice steam leaking during the wash cycle, or if the flapper is warped, cracked, or stuck.