Plcs389dc Parts

I bought replacement hinges and installed them myself. The hardest part of the job was the first part: to remove the oven door you have to lock the old hinges with small brackets, and one side did not want to lock--I had to use a hammer. The door was heavier than it looks, but the only challenge after that was the fact that the edges of the door parts were sharp. I probably should have worn gloves when handling them. You have to take the door apart to insert the new hinges, but it's just... Read more

Followed the directions posted as an answer to Paul's question. Wasn't too bad, took about an our. The one problem I had was that the burners wouldn't ignite at first. I had to go back and tighten the hex nut screws holding down the black burner caps to get the igniter sparks closer to the metal surrounds so that the arc went straight up instead of to the sides. Read more

After replacing the burner twice and verifying the fuel holes and orifice was not blocked, we fixed the problem by replacing the wiring harness P/N: AP3965774. That and making sure the burner was tightly screwed into the range base to ensure the correct spark gap. Read more

AppliancePartsPros was very knowledgeable and helpful. Replaced the "Timer" (computer). The display worked and most of the controls but several of the keypad keys did not work. Replaced the "Panel" (touch-pad) and we have joy. Read more

Ordered a new clock/timer control. This was very easy to install the real trick was removing about 8 wires and 4 plug in connectors from the board and then reinstalling them back in the same location as the were before. I took a photo of the board with my IPhone before taking all the wires off, this made it very easy to reinstall the wires on the same terminals as before. There are 2 additional connectors on the board that a flat ribbon cable from the touch button panel attaches to. Do not just... Read more