Ptw705bstws Parts

Secures the washer lid to the cabinet through hinges at the top. Replace if your lid stanchion is cracked, broken, or causing a loose, misaligned lid.

Fix a washer that won't spin or agitate properly. This brake and clutch assembly controls drum engagement during wash cycles. Moderately difficult repair.

Secures washer panels, brackets, and assemblies. Replace when missing, stripped, or worn to restore proper mounting and reduce vibration.

This screw is a factory fastener used to secure appliance components. Replace a missing, stripped, or corroded screw to keep panels, brackets, and assemblies tight and help prevent vibration or rattling from loose hardware.

• Secures panels, brackets, and internal assemblies at their mounting points
• Replaces lost, rusted, or stripped hardware for a solid, reliable hold
• Helps reduce vibration, rattling, or shifting caused by loose fasteners
• 1/4-20 thread per OEM designation for proper fit where specified

• Disconnect power and, if applicable, shut off water supply before servicing
• Start threads by hand to avoid cross-threading, especially in plastic
• Tighten snugly; do not overtighten to prevent stripping or cracking
• Verify alignment and stability of the secured component after installation

Washer won't start or lid lock fails? This harness clip secures the lid lock wiring to prevent chafing and intermittent connection issues. Quick fix.

Fix unresponsive controls or blank displays on your washer. This interface board restores touch controls and cycle selection. Moderate DIY repair.

Fix detergent not dispensing or leaking from your washer dispenser box. This shower plate gear and seal assembly restores proper spray distribution.

White top cover panel for washer cabinet. Replace if cracked, dented, rusted, or damaged. Protects internal components and restores clean appearance.

External drain hose for washers. Carries wastewater from the tub to your home's drain system. Replace if cracked, leaking, kinked, or disconnected.

Secures and organizes wiring harness in top-load washers. Replace if broken, missing, or worn to keep wires properly routed and prevent chafing.

A small mounting support that provides a stable anchor point for screws used to secure panels or internal assemblies. Replacing a damaged screw platform restores proper fastener engagement and reduces panel movement and vibration. What it does:

• Anchors screws to hold trim, panels or internal components in place
• Restores secure attachment when the original mounting point is cracked or worn
• Helps eliminate rattling, loose panels, or alignment issues caused by a failed mounting surface
• Works with the appliance's existing screws and surrounding hardware to maintain structural fit

• Disconnect power to the appliance before attempting any repair
• Use the correct screws and a properly sized screwdriver to avoid further damage
• Inspect surrounding mounting points and replace any stripped screws or damaged clips as needed

Auger that turns inside the refrigerator ice dispenser to move ice from the bin to the chute, restoring consistent delivery and helping clear jams caused by cracked or worn auger paddles. What it does:

• Rotates to push cubed or crushed ice from the ice bin through the dispenser chute.
• Replaces broken, cracked or stripped auger paddles that cause weak or no ice dispensing.
• Helps stop grinding or scraping noises coming from the dispenser when the auger is damaged.
• Works with the dispenser drive to restore normal ice flow.

• Disconnect power to the refrigerator before beginning any service.
• Remove the ice bin and access panels per your model's instructions to reach the auger.
• Handle the auger carefully in cold conditions; plastic can become brittle and chip.

Fix leaks or loose connections in your washer with this clamp. Secures hoses, sensors, and wiring harnesses. Simple installation takes minutes.

Fix a washer that won't spin or agitate properly with this stator and speed sensor assembly. Includes wiring harness for complete motor control replacement.

Platform bearing retainer that secures the main bearing in the washer transmission housing. Maintains bearing alignment for smooth drum rotation.

8-18 hi/lo 5/8