Pvm1970 Parts

Rear wall mounting plate bracket that supports over-the-range microwaves during installation. Replace if bent, broken, or missing for secure wall mount.

Fix poor venting or back-drafts in your over-the-range microwave with this hood damper assembly. Opens for exhaust airflow, closes to block drafts.

Replace burned-out halogen bulbs to restore bright interior or cooktop lighting. Essential when lights flicker, dim, or stop working. Verify fit with your model.

Fix sensor cook cycles that won't adjust properly or show sensor errors. This humidity sensor monitors moisture levels for automatic cooking adjustments.

This temperature-control thermostat senses compartment heat with a capillary bulb and cycles the heating circuit to maintain your set temperature. Replacing a worn thermostat restores more consistent performance and helps correct underheating, overheating, and erratic temperature swings.

• Regulates heat to match the temperature you set
• Senses temperature via an integral capillary tube and sensor bulb
• Opens and closes contacts to control the heating element or burner
• Failure symptoms can include long warm-up, inaccurate temps, overheating, or uneven results

• Disconnect power and, if applicable, shut off gas; allow the unit to cool completely.
• Handle the capillary tube carefully—do not kink, crease, or cut it.
• Route the sensor bulb and tubing through original clips and path for accurate sensing.
• After installation, perform temperature calibration per service instructions if required.

Glass light cover for microwave cooktop lights. Shields and diffuses bulb from heat, grease, and splatter. Replace if cracked, broken, or missing.

This control panel assembly is the front user interface for your appliance, letting you select settings and start cycles. Replace a cracked or unresponsive panel to restore dependable button response and a clean, factory look.

• Provides the front control interface used to set functions and start/stop operation
• Replaces panels that are cracked, faded, or misaligned
• Restores proper fit and support for user interface components

• Disconnect power at the breaker before servicing; allow any capacitors to discharge
• Remove screws/trim securing the panel and support it to protect attached wiring
• Carefully release ribbon cables/connectors; avoid creasing or pulling on the traces
• Transfer any reusable hardware as needed and test operation before final reassembly

If your microwave runs with the door open or won't start when closed, this door latch body holds interlock switches in position for safe operation.

Secures microwave to wall cabinet mounting bracket. Replace if cracked, stripped, or missing to restore proper cabinet installation and stability.

Microwave won't heat or shuts off randomly? This thermostat regulates temperature and prevents overheating. Direct replacement part for most models.

Fix uneven cooking or loud fan noise with this convection fan motor. Restores proper heat circulation in your microwave for consistent results.

Microwave not heating? A failed magnetron assembly prevents heating and defrosting. This replacement part restores microwave energy generation.

Fix a microwave that stopped heating or made a loud noise. This high voltage transformer powers the magnetron. Moderate DIY repair for experienced users.

Washered screw secures panels, brackets, and internal microwave components. Replace if screw is missing, stripped, or damaged to restore proper fit.

Wire holder clip secures internal wiring in your microwave. Replace if wires are loose or rattling. Verify fit with your model number before ordering.

Support plate that mounts and secures the power control module inside your microwave. Replace if cracked, broken, or missing to properly hold the control board.