Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Refrigerator light not turning on when door opens? The door switch detects door position to control interior lighting. Simple DIY replacement.
Secures the evaporator fan motor inside your refrigerator. Replace if cracked, warped, or broken to restore proper motor support and stability.
I replaced the evap fan motor assembly after thawing out the evaporator. I replaced the evap motor assembly because i damaged it while defrosting the evaporator. Too much heat warped the fan blade and bracket. I replaced the motor because of the abnormal load it was put under when it was making all the noise from trying to spin through the ice buildup on the evaporator. This was all done on the fridge side. Read more
Replacement door spring for refrigerators. Provides proper tension for smooth door operation. Replace if worn, stretched, or broken to restore door function.
Refrigerator not cooling or defrost not working? Main control board manages temperature regulation, cooling cycles, and defrost functions. DIY repair.
Ordered main circuit board. Have had to replace this part previously. Read more
Dispenser tray for Samsung refrigerators. Installs below the ice and water dispenser to catch drips and spills. Replace if cracked, broken, or missing.
Replaced the part. Read more
Fridge light won't turn off or stays dark? This door switch detects when the door opens/closes to control interior lighting. Easy 2-minute DIY fix.
Purchased new evaporator/heater/sensor assembly from appliance parts. Removed new heater, sensor and wire harness from new assembly and from existing unit in refrig section. Then installed new heater and sensor on old refrig evaporator, avoiding complex soldering and recharge with Freon. Once repaired all failure indications cleared and refrigerator section performing like new. Also purchased new heater for water tank and several broken plastic parts that went in in 2 minutes. Changed door... Read more
Rubber grommet that secures the evaporator cover panel in your refrigerator. Replace if cracked, brittle, missing, or no longer holding cover firmly in place.
Initially called repair man and he checked it out , took about half of the freezer insides out to decide the fan was bad. Then he informed me that he did not have part and was going to be on vacation for a week. So I finished tearing apart the freezer to get to part removing the ice maker and rear panel, removed fan and ordered new parts, parts arrived as said and I put back together. Happy to say it is fixed. Read more
The Refrigerator Fan Blade is designed to maintain optimal airflow within your Samsung refrigerator. Crafted as a genuine OEM part, this fan blade ensures reliable performance and a perfect fit for your appliance. Made from durable materials, it withstands constant use and helps to keep your fridge consistently cool. By facilitating efficient air circulation, the Refrigerator Fan Blade helps maintain the ideal temperature, preserving your food longer and reducing energy consumption. Its precise engineering minimizes noise and vibration, enhancing the overall quiet operation of your refrigerator. Easy to install, this fan blade seamlessly integrates with your existing refrigerator system, restoring its functionality without hassle. Compatible with a wide range of Samsung refrigerator models, it is the perfect replacement part for any damaged or worn fan blades. Investing in this genuine OEM part guarantees the longevity and efficiency of your refrigerator, providing you with peace of mind and a better cooling experience. Ensure your Samsung refrigerator operates at its best with the reliable performance of the Refrigerator Fan Blade .
Tested the refrigerator evaporator fan and it would not run. Ordered evaporator motor and fan blade just in case. I went ahead and replaced sensor just as a preventive measure. Did not take long. forgot to order fan clip, but was able to salvage old one. Works Great. Read more
Protective cover that snaps over the compressor start relay on your refrigerator. Replace if cracked, broken, or missing to protect electrical connections.
Removed the lower back cover. I had to pry the cover of the compressor. Replaced the start relay and the refrigerator works again. Read more
Fixes corroded or broken wiring causing motor failure. Connects evaporator fan motor to electrical system. Moderate DIY repair, requires panel removal.
Changed the evaporator fan cover. I was told it comes with the fan motor and it did not so I had to order a fan motor. Then I found the fan wire harness was corroded and broken. I also installed an aluminum tab on the heater element that extends down the drain hole. I also had to clean the back of the fridge and unclog the two drain tubes on the back of the fridge next to the compressor and now it works fine. PS- use a small open end wrench to push the fan blade off the old fan. Read more
Spring that secures the ice cover assembly in your refrigerator. Replace if the original spring is stretched, broken, or missing to restore proper tension.
Fixes refrigerant flow issues and moisture buildup in cooling system. This filter dryer removes moisture and contaminants from refrigerant lines.
Refrigerator door hinge shim installs between hinge and cabinet to correct door alignment. Replace if worn, cracked, or missing to level door properly.
This is a small white bushing that fits around the solenoid in the ice dispenser auger motor assembly. It reduces friction and vibration, allowing the solenoid to operate smoothly when dispensing ice. Replace this bushing if you hear unusual rattling or buzzing from the dispenser area, or if the ice dispenser is not engaging properly.
Found a useful video from AppliancePartsPro. Once I got it apart I figured out what parts I needed. I was able to find the parts for my particular ice maker. Just now finished the repair and works like new again. Read more
Hex bolt for refrigerators. Secures internal components and structural panels. Replace if bolt is stripped, missing, or no longer holds parts tightly.
The Refrigerator Motor Cover Assembly is essential for maintaining the performance of your Samsung refrigerator. This cover protects the motor from dust, debris, and spills, ensuring your appliance runs smoothly and efficiently. Crafted as a genuine OEM part, it guarantees a perfect fit and reliable quality that matches your original components. Installing this cover is straightforward, allowing you to quickly restore your refrigeratorGÇÖs functionality without hassle. By safeguarding the motor, the Refrigerator Motor Cover Assembly helps extend the lifespan of your appliance, reducing the need for costly repairs. Compatible with a variety of Samsung refrigerator models, this cover offers peace of mind and enhances the overall durability of your fridge. Choose this genuine OEM part to maintain the optimal operation of your Samsung refrigerator and enjoy a dependable, long-lasting cooling solution.
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.