Sg10000 Parts

Replaced control board and transformer Read more

Took the front panel off (the door front), disconnected the connector to the door switch and used a wooden clothespin to bypass the door switch. Turned on the dryer to locate loud squeaking sound and found it was coming from the motor area. When I started to take the blower section apart from the motor, that is when I saw the "blower wheel" slipped off the motor shaft. The blower wheel has a "C" clip retainer and compression ring to keep it snug on the motor shaft (but it was loose). Now I... Read more

Ordered my replacement unit from APP, along with a few other "while I am fixing this I should replace that since I am disassembling the washer" parts also from APP. After 2 hours of repair work, the washer is back in full working as new order. The only recommendation to others is make sure you order ALL the parts for the job. Take time to investigate all that you will or might need to replace. An ounce of prevention is worth the pound of cure. Like the old line; measure twice and cut... Read more

Removed shaft with slide hammer and inspected the yoke and gearing replaced the shaft and seals with the shaft kit and replaced the tub bearing. 32 years and still running strong Maytag yeah!!!! Doubt the newer ones will run as long thanks for having the parts. Read more

Used the tool i purchased to remove stubborn brake assembly it worked great Read more

I cannot believe this machine still runs. APP has sold me repair parts for this unit now 3 times. First I wanted to replace the old belts. They still worked but was more a preventative thing. Next was a water control valve a few years ago. This time I noticed a leak near the valve again. I decided to buy a new valve and also replace all the rubber hoses that were 35 years old. The repair took about 3 hours. 1.5 to remove the old parts and do a cleaning that was greatly needed. 0.5 hours to... Read more

I first replaced the two drive belts and the motor springs. That didn't fix it although they did need replacing. I then replaced the two bearings and the brake assy. The washer runs like new. If you replace the brake assembly, you should also replace the bearings. It will save a tear down later on. The Maytag repairman wanted $600.00 dollars to do the job. I did it for less than $200.00. Read more

• Leaking

Perfectly! Replacing Agitator Shaft is not for the faint of heart. Replacing output shaft pinion gear on the bottom of the agitator shaft requires care, experience and patience with pressing/driving drift pins without damaging the gear itself. One slip of the drift/punch or press apparatus will ruin the gear/teeth face and will lead to failure of the transmission internally when put back into service. As best as I can tell the pinion gear is discontinued and no longer available so take care!... Read more