Sgsx305fs Parts

This igniter creates the spark needed to light gas burners on your range cooktop. It generates an electric arc that ignites the gas flow when you turn the burner control knob. Replace this part if burners won't light, take multiple attempts to ignite, or produce weak clicking sounds without lighting.

Burner won't spark or ignite? This spark switch signals the ignition module to light gas burners. Common DIY repair with basic tools, 15-30 minutes.

Color: black. Measures about 2 inches in diameter.

Secures your cooktop to the countertop from below. Includes brackets and hardware. Replace if worn, deformed, or screws are damaged or missing.

This jet holder mounts in the burner assembly for a 12,000 BTU burner. It positions and secures the orifice (jet) and helps seal and align the gas path so the burner lights reliably and produces a steady flame.

• Holds and aligns the burner orifice for the 12,000 BTU burner
• Provides a sealed passage from the valve to the burner head
• Helps restore proper flame height and pattern when the original holder is stripped, cracked, or corroded
• Common symptoms: weak or uneven flame, burner won't light, or jet/orifice will not seat securely

• Shut off gas supply and power; allow the appliance to cool before starting
• Remove grates, burner caps, and burner head to access the holder
• Transfer the existing orifice/jet to the new holder; tighten fittings carefully—do not overtighten into soft metal
• Reassemble, restore gas, and perform a leak check with an approved solution

Air-gas mixing tube that connects the orifice to the burner head on gas cooktops. Replace if clogged, damaged, or missing to restore proper flame mixing.

Foam seal tape creates a tight seal between your cooktop and countertop to contain spills and provide heat isolation. Replace when adhesive weakens.

Secures the jet/nozzle assembly in proper position on your cooktop. Replace if cracked, loose, or missing to restore correct alignment.

This replacement plate restores the proper mounting/cover surface specified in your appliance's assembly, helping keep components aligned, protected, and secure for reliable operation. Ideal for replacing a bent, cracked, or missing original.

• Serves as the specified support/cover plate within the assembly
• Maintains alignment and a secure fit for adjacent parts
• Replace when the original is bent, cracked, worn, or missing
• Symptoms can include rattling, misalignment, loose components, or visible damage in the plate area

• Disconnect power and shut off gas/water supplies (as applicable) before servicing
• Refer to your model's parts diagram to locate and orient
• Transfer or reuse original fasteners and seals if in good condition
• Hand-start screws and tighten evenly; verify alignment and smooth operation after installation

Secures 6mm shafts and spindles on cooktop burners and controls. Replace if parts slip or wobble during use. Confirm 6mm shaft size before ordering.

Left mounting bracket for cooktop installation. Secures cooktop to counter or cabinet. Replace if bracket is bent, cracked, or missing for proper support.

Stainless steel hex washer head screw for cooktop assembly. Replace missing, stripped, or damaged screws to secure components properly during repair.

Used to hold down the jet holder assembly.

This is a variable resistance control that regulates the heat output of your cooktop's heating elements. It allows you to adjust cooking temperatures from low to high by controlling the electrical current to the elements. Replace it when burner heat levels can't be adjusted properly, elements stay on high heat, or temperature control becomes erratic.

Gas pressure regulator for ranges and cooktops. Controls fuel flow to burners. Replace if leaking, cracked, or damaged to restore proper gas delivery.