Shx65t55uc Parts

The Door Handle is an OEM part for Bosch dishwashers. It is installed on the outer edge of the dishwasher door and is used to open and close the door.

The door handle is responsible for providing an easy and secure grip point to facilitate loading and unloading of dishes. It allows for controlled movement of the door through its range of motion.

Symptoms of a bad door handle can include:

• Looseness, wobbling, or detachment from the door
• Chipping, cracking or general wear and tear of the handle surface
• Difficulty grasping or lifting the door with the handle
• The door failing to securely latch in the closed position

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

Adjustable leveling foot stabilizes your dishwasher on uneven floors. Replace if cracked, worn, or missing. Installs at base corners for proper alignment.

Seals the sump area to prevent leaks and ensure proper water circulation and drainage. Replace if cracked, warped, or missing. Verify fit with your model.

Detergent releasing too early or leaking from the dispenser? This seal creates a watertight barrier to prevent premature dissolution. Easy 10-minute fix.

Wire harness for dishwashers. Connects electrical components throughout the appliance frame. Replace if wires are frayed, damaged, or disconnected.

Replacement water hose for dishwashers. Channels water between internal assemblies. Replace if cracked, brittle, leaking, or damaged to prevent leaks.

Replacement door handle for dishwashers. Installs on the outer door panel. Needed when your existing handle is cracked, broken, loose, or missing.

Secures dishwasher hoses to fittings for a leak-resistant seal. Replace if worn or causing drips. Confirm fit with your model number before ordering.

The pump sump seal repair kit contains gaskets and seals that prevent water leaks in the dishwasher's drain pump assembly. Located at the bottom of the dishwasher tub where the pump connects, these seals maintain watertight connections. Replace if you notice water pooling under the dishwasher, reduced drainage performance, or visible water leaks during operation.

This inner door panel forms the inside surface of the dishwasher door. It supports key door components and helps seal the tub, keeping water and heat contained for reliable, quiet operation.

• Provides the structural interior panel of the door
• Mounts the detergent dispenser, latch, and vent components
• Works with the door gasket to contain water and steam
• Typical symptoms include dents/rust, leaks at the door area, or a loose/misaligned dispenser or latch

• Disconnect electrical power and turn off the water supply before starting
• Open the door, support the outer panel, and remove perimeter screws to separate the door halves
• Transfer the dispenser, latch/lock, vent, wiring, and insulation from the old panel to the new one; reuse hardware and seals if in good condition
• Ensure the door gasket seats evenly; after reassembly, run a short test cycle and check for leaks

Exterior front panel for dishwasher doors. Restores appearance when original is dented, scratched, or you want to change color. Mounts over inner assembly.

Dishwasher won't turn on or start? The power module control board regulates cycles, heating, and drainage. Moderately challenging DIY repair.

This replacement screw secures panels, brackets, and internal parts in your appliance for a tight, rattle-free fit. Use it to replace lost, stripped, or corroded hardware and keep components properly fastened.

• Fastens components to the appliance frame or assemblies
• Replaces a missing, stripped, or rusted original screw
• Helps reduce rattling or vibration from loose hardware
• Restores proper alignment of panels or brackets

• Disconnect power and shut off water before servicing
• Refer to your model's parts diagram to locate and place
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening

Dishrack handle for Bosch dishwashers. Attaches to upper or lower rack for easy loading and unloading. Replace if cracked, broken, or missing.

Buttons no longer work or won't start cycles? This control panel push button fixes unresponsive, cracked, or stuck buttons. Straightforward DIY repair.

The Cover is an OEM part for Bosch dishwashers. It serves as a protective barrier over vulnerable inner components. The cover helps prevent damage from spills, shields electronics from moisture, and blocks access to moving parts for safety.

Causes of a bad cover can be normal wear and tear, repeated impact damage, or improper handling during repairs.

Symptoms of a bad cover include:

• Cracks, holes or other physical damage
• Warping or deformation over time
• Loose or improper fit that exposes internal parts

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.