Th21v2w Parts

This membrane breaker is a thin control membrane used in appliance control panels to protect and support the breaker/contact area, restoring reliable button response and electrical isolation. Fits where a flexible membrane provides tactile actuation and insulation. What it does:

• Replaces a worn or damaged control membrane that affects button feel or contact reliability
• Restores proper tactile response for the breaker/control area and helps prevent intermittent operation
• Provides insulation and protection for underlying electrical contacts
• Commonly replaced when buttons feel sticky, unresponsive, or when moisture has compromised the membrane

• High-level replacement — power off and unplug appliance before servicing
• Remove outer panel or console to access the membrane area
• Handle membrane carefully to avoid bending or contaminating contact surfaces

This drain block harness connects the dishwasher drain pump and associated controls to the main wiring, restoring electrical continuity for proper draining and pump operation. Designed to match OEM fit and function. What it does

• Transfers power and signals between the drain pump and control board to enable normal drain cycles.
• Commonly replaced when wires or connector pins are damaged, corroded, or melted.
• Works with the appliance's drain system wiring to maintain secure, routed electrical connections.

• One harness, drain block.

• Disconnect power to the appliance before inspecting or replacing the harness to avoid shock or injury.
• Verify connector orientation and seating; ensure all terminals are fully inserted and locked.
• Inspect related components (pump, clips, grommets) and replace damaged parts as needed for a durable repair.

This wiring harness routes power and signal connections inside the machine compartment to link controls, switches and motors, restoring reliable electrical connectivity for normal operation. What it does:

• Provides factory-style electrical routing between control boards, switches and motors in the machine compartment
• Carries power and control signals to enable motor, pump and control functions
• Failsafe symptom linkage: may be needed when the washer won't start, has intermittent operation, or shows control-related errors
• Helps replace damaged, frayed or corroded wiring that can cause shorts or unreliable performance

• Disconnect power (unplug or switch off breaker) before accessing internal wiring
• Access typically requires removing cabinet or service panels—follow your model's service manual
• Inspect connectors and wire routing; replace only if matching the original harness

This overload is a thermal protection device that mounts on the motor/compressor and opens the circuit when excessive heat or current is detected. Replacing a weak or failed overload helps restore safe startup and protects the windings from damage. What it does:

• Monitors motor/compressor temperature and current draw
• Interrupts power on overheat/overload to prevent damage
• Aids troubleshooting of start/run issues when paired with the start device
• Common symptoms: hums then clicks off, won't start, intermittent shutdown, frequent tripping

• 1 thermal overload protector

• Disconnect power before servicing; allow components to cool
• Access the terminal area on the motor/compressor; remove any cover
• Note/photograph wire positions; transfer wires and fully seat the new overload on the correct terminal
• Inspect the start relay, capacitor, and terminals for heat damage; replace any compromised parts

A small replacement clip-style retainer that secures the appliance toe grille to the cabinet, keeping the grille flush and in place. Replaces worn or broken clips to restore proper fit and appearance. What it does:

• Secures the toe/grille panel to the appliance cabinet so the grille stays aligned and snug
• Stops the grille from sagging, rattling, or popping off during use
• Fits into designated mounting slots or tabs to lock the grille in place
• Commonly replaced when clips are cracked, missing, or loose

• Disconnect power to the appliance before servicing to avoid shock or injury
• Access the toe grille by removing any screws or releasing retaining tabs per your model's service instructions
• Press the clip into the grille/cabinet mounting slot until it snaps in place; verify the grille seats evenly
• If multiple clips are damaged, replace all needed clips for a secure fit