Tns2prcbrbs Parts

The ice dispenser door was not closing tightly. As a result, there was frost build up in the ice chute, which also was allowing ambient air and temperature into the freezer compartment. Upon further inspection, there was black “schmutz” on the ice door, and the rubber ice funnel and deflector parts were deteriorating. Because the door was not closing tightly, I also assumed that the door-closing spring was week. The parts I ordered were: ice door assembly, ice funnel, ice deflector, spring and... Read more

Replace the auger. GE makes this as hard as possible. You have to disassemble almost all of the ice tray mechanism to get the auger out. One tip is that you can unscrew the plastic nut holding the auger in place using a putty knife without having to remove the C-clip holding the plastic nut itself in place. But you still have to disassemble almost the whole thing. You may prefer to remove the C-clip, since reassembling the whole ice crusher "stack" without removing the C-clip can be time... Read more

I removed ice maker, cleared out frozen food to make room for drill, removed broken support, & drilled out old pop rivet (covering the area below with a cloth to catch the metal shavings). Then I carefully straightened the metal support, loosely installed the new support, and pop-riveted it onto the support using the same size rivet. I reinstalled the ice maker, replaced the frozen food, and turned the ice maker back on. No issues. Read more

I welded the auger first but it didnt seem to last. i then took the whole thing apart and found more worn parts so i ordered all of the parts i needed and replaced them. it now works like new. Read more

Ordered exact replacement part and installed in 5 minutes and again we had light! Read more

New switch for water dispenser and new inlet valve. Read more

I replaced the freezer gasket. The part was an exact replacement from the manufacturer, so the fit was perfect and the replacement was relatively straightforward. The most difficult part was getting the gasket bead fitted under the retaining strips and remaining there while I tightened the screws. It seemed to work best to loosen the screws almost completely, pull the retaining strip away from the freezer door body, and fit the new gasket, starting in the middle of the top side, and then... Read more

I welded the auger first but it didnt seem to last. i then took the whole thing apart and found more worn parts so i ordered all of the parts i needed and replaced them. it now works like new. Read more

When we inspected the first time we found that Plactic had broken from the spiral part that for wards the ice. Also there were cracks in two places of other parts. There was a hole in the bottom of the bin. The new spiral was assembled and two new parts were replaced with help from the video and the diagram and the unit worked well. Two months later, ice maker would not forward any ice though the bin was full. We emptied the bin sand have ordered a new part or two in hopes that they will... Read more