Wt1011cw Parts

This softener cap is the small replacement lid for a washer's fabric softener dispenser. It helps contain and direct liquid softener into the dispenser so the machine releases it at the correct time for softer, evenly rinsed laundry. What it does:

• Seals the softener dispenser to prevent drips and spills during filling and cycling
• Directs liquid softener into the dispenser chamber for proper delivery during the rinse
• Helps prevent softener from pooling or leaking into the wash tub between cycles
• Common symptom: softener leaks, pools in the dispenser, or is not dispensed properly

• Disconnect power to the appliance before servicing to avoid injury
• Remove the dispenser drawer or access panel per your model's service instructions to reach the cap
• Press or snap the cap into place until it seats securely; avoid forcing or using excessive tools

This single wire harness restores the electrical connections between components in an appliance, allowing circuits to operate normally and helping resolve power or intermittent control issues. It's a direct-fit replacement used where the original harness is damaged. What it does:

• Re-establishes electrical pathways between controls, sensors, motors or lights
• Helps stop intermittent operation caused by frayed or broken wires and poor connector contacts
• Replaces burned, pinched, or otherwise damaged harnesses that can trigger no-power or failed-function symptoms
• Maintains factory routing and connector interfaces for proper fit and function

• One single wire harness

• Disconnect power (unplug or shut off breaker) before starting any work
• Follow factory routing; avoid sharp edges and heat sources that can damage wiring
• Ensure all connectors are fully seated and locked; secure harness with clips or ties as originally installed

This damper assembly cushions and stabilizes the appliance drum/inner tub to reduce vibration and prevent sudden shifts during operation. It helps keep the drum aligned for smoother, quieter cycles and more consistent performance. What it does:

• Absorbs and reduces drum/tub movement and vibration during spin and agitation
• Prevents abrupt drops or slamming that can cause noise or wear on other components
• Helps maintain proper drum alignment for even load handling and smoother cycles
• Commonly replaced when owners notice banging, thumping, excessive vibration, or a sagging drum

• One damper assembly

• Disconnect power (and water if applicable) before beginning service
• Access typically requires removing the appliance back or front panel; follow the OEM service manual
• Use hand tools; avoid forcing parts—inspect mating mounts for wear and replace if damaged

This friction damper assembly cushions and controls slow, smooth closing of the appliance door or access panel to reduce slamming and minimize wear. It restores damped movement and quieter operation for compatible LG units. What it does:

• Provides controlled, friction-based resistance for door/panel movement
• Cushions closing to reduce slamming and noise
• Helps prevent abrupt swings that can stress hinges or latches
• Restores even, predictable opening and closing motion

• Disconnect power to the appliance before starting any repair.
• Access may require removing an outer panel, trim, or door; follow OEM disassembly steps.
• Handle springs, tabs, and alignment carefully; ensure damper is seated and oriented as OEM specifies.
• Test operation after installation and reassemble panels securely.

This inner tub assembly restores the washer's wash drum that holds and spins laundry for rinsing and draining. Replaces a damaged, cracked or warped inner tub to help stop leaks and reduce noise. What it does:

• Holds laundry while the outer tub fills and the basket spins
• Provides a sealed spinning surface for proper water drainage and rinse cycles
• Replaces cracked or worn tubs that can cause leaks or rubbing/metal-on-metal noise
• Works with the washer's cavitation and spin systems to maintain balance during cycles

• For safety, disconnect power and water supply before removal or installation
• Installation requires disassembly of the washer cabinet and transfer of bearings/seals if applicable
• Inspect and replace tub seals, bearings, and fasteners as needed