We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Fix a washer that won't complete cycles, stops before drain/spin, or has blinking lid lock lights. This electronic control board restores normal operation.
Main outer cabinet housing for washers. Replaces cracked, dented, or damaged exterior panels. Provides structural support and finished appearance.
Molded protective cover that shields wiring from heat and abrasion in laundry centers. Replace if cracked, broken, or missing to protect wires safely.
Fix washer intermittent operation or complete failure with this wire harness. Routes power and control signals between main controls and components.
Paid a friend and he changed the coupler, worked a couple times, then same prob. Hired a pro, ordered a lot of parts, changed drive shaft, transmission/gear case assembly, motor, coupler again. Refunding a lot of unnecessary parts. Read more
Vacuum break component for washer water inlet systems. Replace if cracked, broken, or missing to maintain proper water flow protection and prevent backflow.
Fix intermittent power issues or control failures with this main wire harness. Restores electrical connections between control and power components.
I followed Matt's awesome video from AppliancePartsPros.com to build up my "I can do this" reserves. But here's the story leading up to that point... We purchased our Samsung WF419 on a “Black Friday” special November 2009 expecting to get some good years out of the washer/dryer pair. We don’t run more than 2 or 3 loads a week in the washer, so ours has had relatively little use over the beginning of its anticipated and expected long life-cycle. When the “thumping” started on the spin cycle a... Read more
Inner tub ring assembly installs between the inner and outer tubs of your washer. Replace if cracked, broken, or worn to restore structural support.
Fix grinding noises and spinning issues with a new washplate. Works with the basket to agitate clothes during wash cycles. Moderate DIY repair.
Took replacing gearcase/transmission & the center hub inside the tub under the wash plate. The zipping sound I was hearing was the spline gears between the shaft of the gearcase & the hub. The hub is plastic. The shaft is steel. My iron-heavy water got past the seals & rusted out the shaft spline on the gearcase. When in the "spin" mode the hub would rotate on the shaft & the sensor on the motor actuator sensed the changes in the speed of the gearcase & would shut down the washer. The... Read more
Fix a washer that won't drain or leaves clothes soaking wet with a new drain pump. Removes water from the tub after each cycle. Moderate DIY repair.
If your washer lid won't lock or the cycle won't start, this lid latch secures the lid during operation. Moderate difficulty repair with panel removal.
Top cover lid for your washer that provides access to the drum for loading and unloading laundry. Replace if cracked, broken, or damaged beyond repair.
Replaced lid Read more
Fix a washer that overfills, underfills, or won't drain with a new water level pressure switch. Monitors water pressure to control fill cycles.
Secures panels and components in place. Replace this fastener if stripped, corroded, or missing to restore proper alignment and eliminate rattling.
Ordered boot watched video had no trouble finding ,parts easily entered part num,no problems at all Read more
Fix a laundry center that won't start, stops mid-cycle, or shows error codes with this electronic control board. Moderate DIY repair with basic tools.