Wtw5840bwo Parts

Fixing the problem was quite simple. First, I removed the lid assembly (thanks to the diagrams supplied by AppliancePartsPros.com!). Getting the back two screws out was very difficult because I couldn't see them from the front and I could not move the unit out of the enclosed space. After some trial and error, I located the screws which were 5/16 hex head screws and removed them with a MAGNETIC nut driver. (The magnet assures that the screw will not drop down into the mechanism). Second, I... Read more

Watched a video online, the project took about 20 minutes, went well, parts fit good, the video was very helpful in getting the wash machine up and running. Read more

I was stunned and amazed that the directions we watched on you tube were spot on. It was a repair that I was able to do myself. I only needed to replace the latch and that fixed the problem, your tech was knowledgeable and the products came right away, thank you for saving me a costly repair bill. Read more

Purchased water inlet valve and new hot and cold water hoses. Unscrewed about 5 screws that were holding the top of the washer in place then slide the top forward and up. Released the control top it popped off no screws. Disconnected the wires attached and unscrewed 2 screws holding the valve in place the popped that off. Popped in a new valve and repeated the process in reverse. Boom done! Very simple works like new! Read more

Completely removed dryer drum cleaned surfaces ready for paint applied paint acquired from you it did a wonderful job with one can of paint will use for a while and acquire another can of paint for second coat thank you so much for your help the whirlpool dryer drum paint was exactly what it said it would do Read more

Replaced cold water valve and lid lock assembly; locks have a tendency to fail on these washers, I think this is my third one. Both jobs are super easy. Disconnect water lines and unplug the washer, remove 5 hex screws that hold on the rear upper panel, 2 screws that hold the lid, and 1 screw that holds a little metal cover. The cold water valve is held in by 2 vertical screws. There are 2 mildly tricky parts: (1) the electrical connectors were too tight to remove by hand and required needle... Read more

Researched it on YouTube. Used your video. Very very helpful! Your video proved to me that I should not be intimidated to try the repair. Following the step by step instructions, the whole thing took me even less time than I thought it would. Read more

We found the pump online at AppliancePartsPros.com for our model of Maytag. When we found the part, there was a video posted that was for our exact pump and washer. After watching it, we called Appliance Parts Pros to verify the part. The customer service representative was incredibly helpful and confirmed our diagnosis. We ordered the pump as well as hoses and clamps in case we needed them. We ordered them overnight delivery and the customer service rep said that we might not receive it... Read more

Replaced it with a new gear housing assembly. It was some what difficult removing the spindle hub. Read more