Machine Plate Parts

This is a small support bracket that holds the cooking rack or shelf in place inside the microwave. It mounts to the interior cavity wall and keeps the shelf level during use. Replace this part if your microwave shelf is wobbly, tilting, or no longer stays in position.

This transmission and support assembly drives and stabilizes the wash basket. It converts motor power into agitation and spin while supporting the tub, helping resolve no-agitate/no-spin complaints and loud operation for reliable cleaning performance.

• Transfers motor power to the drive system for agitation and spin
• Supports the basket and helps maintain alignment during operation
• Helps correct no agitate, no spin, or weak/intermittent spin
• Can address grinding/rumbling noises or oil traces from the center

• Disconnect power and water before servicing; wear gloves and eye protection
• Appliance and assembly are heavy—use assistance and protect flooring
• Removal typically requires accessing from top and bottom to remove agitator/basket and drive hardware
• After installation, run a test cycle to ensure smooth agitation, proper spin, and no leaks

Factory replacement support plate for electric and gas ranges. Covers and supports internal components. Replace when bent, cracked, or missing to restore proper alignment.

This is a metal support bracket that helps secure and stabilize the firebox or internal cavity structure of the range or cooktop. It provides structural reinforcement to keep components properly aligned during operation. Replace this bracket if it is bent, broken, or corroded, which can cause misalignment of internal parts or rattling noises during use.

Guides the upper dishrack as it slides in and out. Replace if cracked, broken, or if rollers have fallen out, causing loose or unsteady rack movement.

Secures the middle water feed tube to the upper rack in your dishwasher. Replace if cracked, broken, or missing to keep the conduit properly aligned.

Secures the middle spray arm inside the dishwasher tub for proper alignment and rotation. Replace if cracked, broken, or missing to restore arm stability.

Includes suspension pads.

This washer shock absorber mounts between the outer tub and base to control movement during spin. Replacing a worn damper restores stability, reduces vibration and noise, and helps prevent the machine from walking or banging.

• Stabilizes the tub during spin by absorbing and controlling movement
• Reduces vibration and cabinet noise for smoother operation
• Helps the washer reach and maintain proper spin speed
• Worn shocks can cause shaking, banging, or walking during spin

• Disconnect power and water; use gloves and protect the floor.
• Access from the front or rear depending on model; remove panels as needed.
• Support the tub, then remove fasteners at both ends; install the new damper in the same orientation and tighten securely.
• Reassemble, level the washer, and run a test spin to check for vibration.

Supports and centers the inner tub in front-load washers. Replace if cracked, corroded, or broken to restore proper drum alignment and balance.

Support rod that props up the lift-up top on your range. Holds the top panel securely in the raised position for cleaning or servicing. Replace if bent or missing.

Spider arm connects the wash basket to the drive shaft in front-load washers. Replace if cracked, corroded, or broken to restore proper basket support.

Secures the small clear lens in your range's control panel opening. Replace if cracked, broken, or missing to restore a snug fit and proper appearance.

Mounting bracket that secures and stabilizes internal washer components. Replace if broken, cracked, or damaged to restore proper panel alignment.

Mounting bracket that secures and stabilizes internal components in your refrigerator. Replace if cracked, broken, or missing to restore proper alignment.

This is an orifice carrier assembly used to convert a range from natural gas to liquid propane (LP) operation. It includes the properly sized orifices needed to regulate LP gas flow to the burners. This kit is needed when installing a natural gas range in a location that uses propane, or if burner flames are too high or too low after a gas type change.