Tool Qt Padding Bi - Model Parts

Specialized service wrench for washer transmission and hub fasteners. Essential tool for technicians performing maintenance on specific washer models.

This is a rubber or foam impact absorber pad that sits between the outer tub and the washer frame to dampen vibration and reduce noise during the spin cycle. These pads wear down over time from repeated compression. Replace this part if your washer is excessively noisy, vibrates heavily during spinning, or if the existing pad appears flattened or deteriorated.

Sound dampening pad for dryers. Installs inside the cabinet to reduce vibration and noise. Replace if worn, torn, or missing for quieter operation.

Lint brush tool for cleaning dryer vents and lint traps. Replace your worn or missing brush to maintain proper airflow and remove built-up lint deposits.

Water hardness test strip tool for dishwashers. Tests mineral content in tap water to help determine optimal detergent and rinse aid settings.

Sound dampening pad that installs inside your washer to reduce vibration and noise. Replace if the original pad is cracked, torn, missing, or worn out.

Replaces worn or damaged washer sound dampening isolator. Reduces vibration and noise during wash cycles. Essential when original is cracked or missing.

Dryer Vent Test Kit ensures your dryer's vent system is operating properly. Kit includes two tests depending on the location of your dryer's lint screen: One for the lint screen in the top of your dryer, and one for the lint screen in the front of your dryer. Instructions included.

Sound dampening pad for washers. Reduces vibration and noise during operation. Replace if worn, cracked, or missing to restore quiet performance.

Spanner wrench tool designed for washer repairs and maintenance. Essential for tightening or loosening retaining nuts during installation or service work.

This specialized plier tool is designed for removing and installing the spring clamp that secures the door boot seal to the outer tub of a front-load washer. The tool provides the leverage needed to safely stretch and release the tension spring without damaging the rubber boot. Use this tool when replacing a torn or moldy door boot seal, or whenever the spring clamp needs to be removed during washer maintenance.

This damper is the refrigerator air-control flap that regulates airflow between compartments to help maintain consistent temperatures and proper cooling. It replaces a worn or stuck damper to restore normal airflow and temperature balance. What it does:

• Opens and closes to direct cold air where needed between freezer and fresh-food sections
• Helps maintain even temperatures and prevents one compartment from getting too warm
• Common symptom: uneven cooling or warm fresh-food section despite running compressor
• Common symptom: damper stuck or not moving, causing poor temperature control

• Disconnect power to the appliance before starting any repair
• Remove interior panels to access the damper; use basic hand tools
• Handle the damper and any wiring harness carefully to avoid damage
• After installation, verify damper operation and allow time for temperatures to stabilize