Power Nut Installation Parts
Genuine Frigidaire part
By: Frigidaire
Part Number: 316032411
Oven won't heat to correct temperature or won't turn off? The thermostat regulates oven heat. DIY repair typically takes 15-60 minutes with basic tools.
This part fixes the following symptoms
-
Oven is too hot
-
Little to no heat when baking
See more...
Do-It-Yourself Stories from Customers like You
Oven thermostat was broken Johnny C. • Laurel , MS • February 08, 2016
Removed old thermostat and pulled old thermocouple fron oven. ran new thermocouple to oven and put in clip, tistalled new thermostat using 2 phillips head screws, done.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3391914
Dryer won't heat or overheats? The high limit thermostat monitors drum temperature. Moderate DIY repair with heater housing access required.
Do-It-Yourself Stories from Customers like You
My whirlpool dryer was not getting hot Anthony D. • Sanibel , FL • May 01, 2016
I purchased a new heating element. Very easy to fix in about twenty minutes
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 218396700
Plastic mounting block that anchors the refrigerator door handle assembly. Replace if cracked, broken, or causing a loose handle from repeated use.
Do-It-Yourself Stories from Customers like You
Broken handle Jack M. • Memphis , TN • November 04, 2018
No problem, 1 min to fix
Read more
More
Genuine Samsung part
By: Samsung
Part Number: DC47-00017A
Dryer won't heat or stops heating mid-cycle? The high limit thermostat cuts power when temperatures spike. Easy 15-minute fix with video guide.
Do-It-Yourself Stories from Customers like You
My dryer would not heat up Chris R. • Glen Saint Mary , FL • January 07, 2015
When starting my dryer the motor would power up and rotoe the drum and blower. Afetr about 20-30 seconds the igniter would come on then the gas valve would open and I would get heat for about 6 or 7 seconds then it would shut off. I know the burner is suppoed to cycle on and off but once the burner shut off it would not come bqack on unless I shut the dryer off and then back on. I checked for continuity on the thermistor, the thermal fuse and the high temp sensor. All three of them appeared to...
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10467289
The Water Temperature Sensor is an OEM part for Whirlpool washing machines. This sensor ensures the water is reaching the proper temperature at each stage of the wash cycle. Note: The sensor does not include the seal W11590578. Order separately if needed.
Causes of a bad temperature sensor can be failures over time due to mechanical wear, thermal stress on electronic components, or damage from leaks/flooding inside the unit.
Symptoms of a bad water temperature sensor include:
- Inability to switch between wash steps or advance through the cycle
- Erratic or inconsistent temperature readings
- Failure alarms or error codes displayed
- Improper or incomplete washing even on high heat settings
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Do-It-Yourself Stories from Customers like You
F2 e3 error code on front load duet washer Mark M. • Saratoga Springs , NY • September 16, 2016
Replace the water temperature sensor and still had the error code. While I had the back of the machine open I ran the washer. I traced the black wires from the temperature sensor and wiggled them as the washer was running. At one zip tie every time i moved the wires the washer would stop running and the error code would flash. Sure enough, like many others posted, the vibration from the machine had split the wire. I spiced the wire back together and have not had a problem since.
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 316240600
Secures the ignitor assembly to your gas cooktop burner base. Replace if screw head is stripped, threads damaged, or screw is missing after disassembly.
Do-It-Yourself Stories from Customers like You
Slow to ignite Matthew F. • East Peoria , IL • October 07, 2019
It took a little longer then I was hoping but wasn’t terrible. If the burner is very old at all make sure to get the new screws. Both of mine snapped when trying to remove them. The new one works great.
Read more
More
Genuine Ge part
By: Ge
Part Number: WB1X1293
Secures the igniter to the burner assembly in gas ranges and ovens. Replace if stripped, missing, or damaged during igniter replacement or repair.
Do-It-Yourself Stories from Customers like You
Failure to hold temperature after preheating. Michael D. • Wilmington , DE • January 07, 2023
I was getting really frustrated with our oven. It would preheat to the correct temperature, then slowly lose heat until it was down to about 200 degrees. So it took about two hours to heat a pizza!
Finally decided to repair the oven myself, rather than pay $300.00 to have a repair person come out. Ordered the replacement igniter from AppliancePartsPros.com, and it arrived in two days.
I followed the instructional video on the AppliancePartsPros.com website, and it was going well until I...
Read more
More
Genuine Ge part
By: Ge
Part Number: WR01X10315
Secures the auger shaft in the icemaker assembly. Replace if stripped, cracked, or loose, preventing proper ice transport from bin to dispenser.
Do-It-Yourself Stories from Customers like You
The cover crusher on my ge ice maker bucket shattered it hasn't been working well since we originally got the refrigerator sometimes we had to scoop ice out rather than get it through the door William H. • Cary , NC • August 15, 2015
I looked for a site that sold replacement parts for my make of GE refrigerator. I found AppliancePartsPros, and was very surprised at how organized it was. By entering the model number of my refrigerator, I was shown a set of (approximately) 8 general parts diagrams for my refrigerator. I chose the ice making/dispensing diagram. I matched the part that shattered (from use) to what was on the diagram.
What I didn't know was how to install the part. I saw references by other customer comments to...
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 137539200
Dryer won't heat or shows E66 error? The thermal limiter prevents overheating by monitoring airflow. Moderate DIY repair, requires rear panel access.
Do-It-Yourself Stories from Customers like You
Frigidaire dryer error e66 then door open Nolan R. • Hoboken , NJ • February 06, 2017
My Electrolux Frigidaire Gas Dryer stopped working and I got an error code E66 that the thermal limiter blew from over heating. The E66 code stops displaying after the initial code and you will then get a door open message. I replaced the thermal limiter and the thermostat just to be sure which part at the problem. The job is hard because you have to take apart the entire dryer and remove the drum. Would be a tough project to complete on your own.
Read more
More
Genuine Lg part
By: Lg
Part Number: MJB63190001
Replacement mounting stud for refrigerator door handles. Installs inside the door to secure handle assembly. Needed when stud is damaged or missing.
Do-It-Yourself Stories from Customers like You
Broken freezer arm Lawrence D. • Estero , NC • May 14, 2017
Ordered new freezer arm
Read more
More
Genuine Speed Queen part
By: Speed Queen
Part Number: D510523
Fix dryer overheating issues with this thermistor assembly. Monitors temperature and sends readings to the control board. DIY-friendly repair part.
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 134786100
This moisture sensor consists of two metal strips typically mounted inside the dryer drum area that detect the moisture level in clothing during a drying cycle. It signals the control board to end the cycle when clothes reach the desired dryness. Replace this sensor if your dryer shuts off too early with clothes still damp, runs too long, or if the auto-dry cycle no longer functions properly.
Do-It-Yourself Stories from Customers like You
The sensor-moisture clip was broken off and needed to be replaced. Edgar D. • Bradford , AR • April 06, 2014
Simple unscrewed the set screw, removed the broken sensor-moisture part, attached the leads, and reattached the part to the back of the dryer. Took about 4 minutes.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP307473
Dryer won't start or heat? A blown thermal fuse cuts all power to protect against overheating. Easy 30-minute DIY fix with multimeter testing.
Do-It-Yourself Stories from Customers like You
Catastrophic failure of the dryer cycling thermostat in a maytag neptune super stack Richard M. • Cornish , NH • October 19, 2020
Through 15 years of vibration, the Cycling Thermostat evidently had degraded to the point where one electrical connection or more came loose and caused a short. There is also a possibility that the Bakelite section of the Dryer Cycling Thermostat body separated from the metal base, simultaneously exposing all four connections to a short. The thermostat literally exploded into chunks and dust. There was a heavy arcing and then, thankfully, the thermal fuse blew and shut down power to the short...
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 215503203
Specs: 10-16 X 0.500
Do-It-Yourself Stories from Customers like You
Broken handle Jack M. • Memphis , TN • November 04, 2018
No problem, 1 min to fix
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP33001762
Dryer won't start or run? A blown thermal fuse is the likely cause. This safety component cuts power if temperatures get too high. Easy 15-min fix.
Do-It-Yourself Stories from Customers like You
Catastrophic failure of the dryer cycling thermostat in a maytag neptune super stack Richard M. • Cornish , NH • October 19, 2020
Through 15 years of vibration, the Cycling Thermostat evidently had degraded to the point where one electrical connection or more came loose and caused a short. There is also a possibility that the Bakelite section of the Dryer Cycling Thermostat body separated from the metal base, simultaneously exposing all four connections to a short. The thermostat literally exploded into chunks and dust. There was a heavy arcing and then, thankfully, the thermal fuse blew and shut down power to the short...
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 316540900
The Screw is an OEM part for Frigidaire ranges and cooktops. This part secures the burner head in place, ensuring proper alignment and functioning of the burner.
Causes of a bad burner head screw can include loosening due to repeated heating and cooling cycles, damage from impact or mishandling, or simply wear and tear over time.
Symptoms of a loose or missing burner head screw include:
- Uneven or irregular flame pattern on the burner
- Burner head not sitting flush or properly aligned
- Burner head wobbling or moving during use
- Potential gas leaks if the burner head is not securely fastened
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Ignitor failed / screw that attached burner to ignitor stripped Michael M. • Roundhill , VA • May 17, 2015
Ordered new Ignitor / Orifice and screws
Mike was a great resource, he helped me thru the project.
Read more
More