Lid Switch Parts

If your washer won't start or stops mid-cycle, this lid switch assembly detects lid closure to restore safety interlock. DIY-friendly, installs in 15 minutes.

Washer won't change cycles or settings not responding? This selector switch routes power to temperature and speed controls. Moderate DIY repair.

Fix a washer that won't fill properly, overfills, or stops mid-cycle. This pressure switch restores proper water level detection. Simple 10-minute repair.

This Smart ATC temperature switch senses and helps regulate oven temperature for more consistent cooking. It replaces a failed switch to restore correct temperature feedback to the range control for accurate heating. What it does:

• Detects oven temperature and sends a signal to the control so heating elements cycle appropriately
• Helps correct issues where the oven runs too hot, too cold, or cycles erratically
• Works as part of the temperature control system—does not include the main control board
• Replaces a worn or failed temperature/A.T.C. sensor switch to restore proper temperature sensing

• One temperature switch (Smart ATC)

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Access typically requires removing the oven control panel or back panel; keep track of screws and wire connections
• Handle the switch and connector gently to avoid damage; verify wiring matches original before reconnecting

This pressure switch monitors the water level inside the washer tub and signals the control board when the correct fill level has been reached. It connects to a small air hose that runs to the tub. Replace this switch if your washer overfills, underfills, does not fill at all, or fails to advance past the fill cycle.

This is an electrical relay used in the washer's motor or control circuit to switch power to specific components during operation. It helps regulate the timing and function of the wash and spin cycles. Replace this relay if the washer motor won't start, the machine hums but doesn't agitate or spin, or if cycles fail to advance properly.

Fix washer overfilling or incorrect water levels with a new pressure switch. Solves fill problems across load sizes. Most installs in 5-10 minutes.

Washer overfilling or running without water? Your pressure switch likely failed. This switch monitors water levels to prevent overflow problems.

This is a 7-position temperature selector switch that mounts on the washer's control panel and allows you to choose the water temperature for each wash cycle. It controls the mix of hot and cold water entering the tub. Replace this switch if your washer fills with the wrong water temperature, only uses hot or cold regardless of the setting, or if the temperature dial no longer clicks into position.

If your washer won't advance cycles or overfills, the pressure switch likely failed. This DIY repair restores water level sensing in 15-30 minutes.

Fix an oven that won't switch between bake and broil modes with this rotary selector switch. Controls oven functions and temperature selection reliably.

Washer won't start or stops mid-cycle? This dual lid switch kit restores safety interlock function. Moderate DIY repair in 30-45 minutes.

Fix washer not filling correctly or overfilling with this water level pressure switch. Restores accurate fill control when cycles don't stop at proper levels.