Andrew K Eaton , OH February 10, 2015 Washer would not fill to the proper level sometimes it would fill agitate a few times turn the pump on and drain a little then fill again sometimes it would pause or a cycle might take all day I replaced the water lever/electric pressure switch. Immediately the washer ran like a new machine. No problems pausing or stopping to add water and draining as before. This repair is very simple and takes less than 10 min. All you have to do is remove two phillips screws on the panel just below all the controls. Once removed the pressure switch is on the left side with a clear rubber tube attached with a spring clip. Simply squeeze the clip together with some pliers and slide it down then remove the tube. The wires for the switch are simply in a plug and come right off. Install new part in reverse order. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers
Tom S Wellesley , MA March 12, 2014 The float switch on our washer /dryers have been not working Very simple fix, take off front cover , remove pressure hose, float switch snaps in place and the wiring harness snaps in Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers