Leak Blower Regular Starter Parts

I ordered a new timer and installed it with the help of the videos provided and this did not solve my problem so I chated with the pros @ Appliance Parts Pros and told them my problem and they told me the problem and recommended the part I needed and With the incredibly fast shipping I had the part the next day. I installed it and now my dryer timer works great.Thanks to APPs for their help and ease of ordering and fast shipping. I highly recommend AppliancePartPros and will definitely use... Read more

Blower wheel and clamp replacement. Initially, we replaced both the belt and drum roller wheels but that did not stop the noise. By reviewing videos on YouTube and AppliancePartsPros, we suspected that the blower wheel could be problematic, even though with front panel of dryer off, we did not see any visual clues to support that theory. Purchased the replacement clamp as well, just for good measure (and it was inexpensive). Note: we did call AppliancePartsPros with our model AND serial numbers... Read more

Replaced Blower Wheel. Stress cracks at center of blower wheel. Read more

I unscrewed the 3 Phillips screws on the back of the dryer controls housing, then it folds forward for access to each control switch. the old one popped out, and I swapped the wires using a needle nose pliers, one by one, from the old switch to the new switch. The part was an exact fit, and popped right back into the housing. I screwed the 3 screws back in, pushed on the new knob, and it looks and works like new ! Read more

First checked the power then took off the compresser connections cover looked for burnt wires or loose or disconnected wires they were none of those I then removed the wires from the starter an overload protector removed them checked both for contunuaty overload protector no contunuaty then I checked the 3 poles on the comp. for contunuaty they were ok then I checked each pole to ground on the com. to final check that the comp. was still good Read more

We replaced the starter and relay. Unit is working properly. We saved over $150 by replacing the parts in question. Read more

• Tray won't turn

I googled the make and model, and found the part on AppliancePartsPros.com. The underside of the oven has a metal grille with numerous openings of various shapes and sizes. There is a rectangle that is punched into this grille, just below the motor. I pried between the vent holes to snap the connections near the perimeter on the punched rectangle. I only did this on three sides. Then pry up the rectangle away from the connected side. Undid the hold down screw, separated the motor from the... Read more

• Tray won't turn

Start bye removing the three screws that hold the underside of the microwave up. Once those are undone, the panel pivots down. You then need to un-attach the lights so the panel will totally come off and out of the way. The motor is plainly visible. Remove the power plug and remove the one screw then it twists out of its slot. Install the new motor and reverse the directions. Read more

At first, I thought that it was the defrost timer, but when I took apart the freezer, I found that the evaporator fan motor wasn't running, so I replaced it. Read more

Replaced the convection fan motor. Read more

I replaced the heating element and all of the thermal/high cutoff fuses and thermistors even though only the heating element tested "open" (there was a crack in the element) just to be safe. Also for the "jet airplane" sound the fan housing bearing was bad. I replaced that a well. Now it works like it should and is quiet again! However, I broke the fan blad removing it for the reinstall on the new fan housing but I ordered it at 6 at night and had it the next morning. Amazing and thank... Read more