Wf203ans/Xac Parts

With the video that was made from appliance pro.Help me out one hundred percent to understand what I was dealing with Read more

Replaced door lock switch. Read more

I followed Matt's awesome video from AppliancePartsPros.com to build up my "I can do this" reserves. But here's the story leading up to that point... We purchased our Samsung WF419 on a “Black Friday” special November 2009 expecting to get some good years out of the washer/dryer pair. We don’t run more than 2 or 3 loads a week in the washer, so ours has had relatively little use over the beginning of its anticipated and expected long life-cycle. When the “thumping” started on the spin cycle a... Read more

Normally, I hire someone to come fix washer or dryer problems as time is limited and if the cost is close or more than the machine, I buy a new one instead. But since we are on shelter-in-place, I figure I could repair it since I have more time on my hands and my brother assured me, it was not hard to do. I took the top panel, door off and then looked online to find a service manual, which allowed me to take the front panel off. My suspected drain hose was the failure mode: the rubber tube... Read more

I found a youtube video about replacing the hot water valve in a Samsung washer. It looked pretty easy. I had been very satisfied with an earlier order from AppliancePartsPros.com, so I ordered this part on Sunday after 9PM, standard delivery, hoping to get the part by the end of the week. I was flabbergasted to receive the part TUESDAY MORNING! Wow! I followed the instructions in the youtube video exactly. It took around 15 minutes, because I was being very careful not to drop screws in... Read more

I took apart the washer to find both of the weight balancers had broken in 2 and were banging around. They had also caused the boot seal to rip. I removed the broken weight balancers and replaced them along with a new boot seal. There was one small spot with the seal wasn't fully attached to the outer drum so I had to take it back apart to fix that minor error on my part. Otherwise, it was a fairly easy fix. Read more

• Door latch failure

I removed the wire and rubber seal in order to get to the door lacth then I unscrewed the three screws popped out the latch put the screws and the rubber and wire back and tested the washer. The door now locks and I can wash again...YEPPPPY Read more

The error code implies a faulty fill valve. This was not the case for me. Replacing the main PCB assembly solved the problem. I have run two full loads since the repair with no problems. Read more

I ordered new door gasket, front and rear clamp for gasket and installed them. Read more

I first check the schematics to find the heat sensor. On my model it's c on the control panel. I checked the continuity on the orange and white wires. It showed some continuity but not much. I then went to the heater element and found the orange and white wires going to the thermistor. Turns out the heater element and thermistor need repalced. Read more

REPLACED BACKFLOW CHECK VALVE DIAPRHAM & PUMP Read more

Ordered new dispenser assembly and replaced it. Fixed the problem. Read more

• Noisy
• Will not drain
• Leaks water

My washing machine was not draining. I opened the access panel in the back. Checked both the incoming water line and the outgoing line. Both lines were open. Checked inside the pump for a foreign object, and it was also clear. I decided to replace the pump. Ordered the pump online. It's fixed and much quieter. My first washing machine repair! Read more

My wife noticed a knocking noise on our front load Samsung washer. Lucky for me she noticed it before it got to extreme. I looked online and found the video from Appliance Parts Pros which outlined the repair even though it was a different brand. Once disassembled I found what appears to be the common problem, one of the arms was cracked on the drum spider. The drum bearings and seal was still in good condition. After inspection I found several parts needed replaced from the drum rubbing and... Read more

I fixed it by replacing the door switch assembly, door hinge and hinge bushing. The videos you provide was a great help on fixing the problem in no time at all. Ordered parts arrived the next day plus the parts were the correct ones. Read more