Sears Canada Refrigerator Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP22002263
Illuminates the dryer drum for better visibility when loading and unloading. Replace when bulb burns out or fails to light. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
Squeaky noise and not fully drying David H. • Santa Clarita , CA • September 20, 2019
Originally the dryer was squeaking a lot, so I purchased a new belt tensioner, but the original tensioner was an old-style no wheel tensioner, so that wasn't the source of the squeaking.
I saw a lot of lint had built up inside the unit where there shouldn't have been that much. So I viewed a few videos on the Appliance Pros site and saw that the rear wheel guides were the cause of the squeaking and the rear felt drum and blower housing seal needed to be replaced. The rear blower housing was...
Read more
More
$15.55
- Compare At:
-
$18.50
- You Save:
-
$2.95
Genuine Whirlpool part
By: Whirlpool
Part Number: 279318
Includes screws and wire connectors. For the complete terminal block kit use 279320.
This part fixes the following symptoms
-
No heat or not enough heat
See more...
Do-It-Yourself Stories from Customers like You
Loose wire in back caused a short and burned out plug insulator etc William W. • Pottsboro , TX • February 15, 2019
I ordered the parts through AppliancePartsPros.com. They were delivered the next day. I installed them and the dryer works great.
Read more
More
$56.95
- Compare At:
-
$67.20
- You Save:
-
$10.25
Genuine Whirlpool part
By: Whirlpool
Part Number: W11613302
Heat-resistant fiberglass gasket seals your oven door perimeter to maintain consistent temperatures. Replace when worn, frayed, or flattened to restore efficiency. Verify fit by model number.
More
$35.57
- Compare At:
-
$42.33
- You Save:
-
$6.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10476828
Dryer stops early on auto cycle but works on timed? The moisture sensor control board monitors dryness levels. DIY-friendly repair, 15-20 minutes.
Do-It-Yourself Stories from Customers like You
Kenmore elite dryer routinely stopped after a few minutes when set on the moisture cycle but finished completely when set on timed cycle James L. • Brandywine , MD • December 06, 2014
Did some research via the internet and figured the problem was likely the moisture control board. Watched a video of the repair of a similar unit in order to locate the moisture control board. Used the chat feature with one of the Appliance Parts Pros to get a schematic of the dryer and advice about where to use the putty knife to release the springs for access to the board. Thanks to the lady I chatted with for expert advice. Once the actual task was started, the repair took 15 or 20...
Read more
More
$189.84
- Compare At:
-
$213.76
- You Save:
-
$23.92