Parts for Lg LWHD1500ER / AWYAHDP: Section 1 Parts

This drawing capacitor helps provide the extra electrical boost motors need to start and run smoothly, restoring normal operation and reducing strain on the motor. It's a direct-fit replacement when the original capacitor fails. What it does:

• Supplies a timed voltage boost to assist motor startup and rotation
• Helps reduce motor humming, slow starts, or failure to start
• Promotes consistent motor speed during operation for reliable performance
• Can prevent added stress on the motor windings when functioning properly

• One drawing capacitor

• Disconnect power to the appliance before attempting any service
• Capacitors can hold charge—discharge safely and use insulated tools
• Verify correct orientation and secure connections; replace only with the exact part number

This clamp secures a line or connection inside your appliance, maintaining a tight fit under vibration. Replacing a fatigued clamp helps prevent leaks or disconnections and keeps components anchored so the system operates reliably.

• Holds a line/fitting firmly to keep the joint sealed and secure
• Helps prevent leaks or disconnections at hose/tube connections
• Resists vibration that can loosen fittings during operation
• Replace if bent, weakened, or corroded, or if the connection repeatedly loosens

• Disconnect power and, if applicable, shut off water supply before service
• Note clamp orientation and routing; seat the clamp just behind the fitting bead/stop
• Use the correct tool for your clamp style to compress or tighten evenly
• After reassembly, restore utilities and test for leaks or movement

This remote controller assembly replaces a malfunctioning TV remote control PCB and housing to restore infrared/IR command transmission and on-unit button control. Ideal when the remote stops responding or buttons become unresponsive. What it does:

• Replaces the internal PCB and button assembly that sends IR signals to the TV.
• Restores remote control functions like power, volume, channel, and input selection.
• Helps resolve symptoms such as no response from the remote, intermittent commands, or stuck/non-working buttons.
• Works with the existing remote cover and batteries if those components are reused.

• Disconnect power to the TV and remove batteries from the remote before replacing the assembly.
• Use appropriate small screwdrivers and keep track of screws and clips; handle the PCB by its edges to avoid damage.
• Reassemble carefully, insert fresh batteries, and test all functions after installation.

This evaporator assembly replaces the freezer evaporator coil and drain pan to restore proper cold-air circulation and manage defrost water. It's a direct-fit service part used in compatible LG refrigeration units. What it does:

• Circulates refrigerant and removes heat from the freezer compartment to maintain cold temperatures
• Collects and channels defrost water into the drain pan to prevent pooling or ice buildup
• Helps resolve symptoms such as poor cooling, frost accumulation on the evaporator, or water leaking/overflow in the freezer area
• Works with the appliance's defrost system; a failed evaporator can trigger frequent defrost cycles or temperature fluctuations

• One evaporator assembly

• Disconnect power before beginning any repair and work on a stable, dry surface
• Access usually requires removing freezer panels and possibly the evaporator cover; keep track of fasteners and seals
• Inspect and replace related gaskets, insulation, or drain components as needed to ensure a proper seal and drainage

This installation kit includes the manufacturer-specified hardware used to secure and align an appliance during setup. Use it to replace missing or damaged install hardware and restore a safe, stable, factory-correct fit in the opening. What it does:

• Provides required mounting hardware for proper installation
• Helps prevent shifting, rocking, or tipping when the appliance is used
• Aids in correct alignment and spacing within the cabinet/opening
• Replaces lost or damaged original install parts

• One installation kit

• Disconnect power (and gas/water, if applicable) before starting
• Follow your model's installation instructions for bracket locations and fasteners
• Use appropriate anchors for wall/floor material as specified by the manufacturer
• After installation, verify the unit is level and securely anchored