Parts for Ge DDP1400SAB: 02 - Section2 Parts

This genuine-style door gasket replaces a worn or damaged refrigerator door seal to restore a tight closure and help maintain proper cooling. It stops cold air loss and reduces frost build-up when sealing correctly. What it does:

• Seals the refrigerator door to keep cold air in and warm air out
• Helps reduce frost and moisture buildup inside the compartment
• Can improve cooling consistency and reduce energy waste when effective
• Commonly replaced for visible cracks, tears, or a flattened seal that no longer closes snugly

• Disconnect power to the appliance before starting any service
• Clean the door frame and mating surface before installing the new gasket
• Align the gasket evenly around the door and press into the channel until fully seated
• Check door alignment and hinges to ensure a proper long-term seal

This bearing seal helps protect a dryer drum or motor shaft bearing from lint, moisture and debris to keep the bearing turning smoothly and extend service life. It's a small replacement part used where a tight seal is needed around a rotating shaft. What it does:

• Seals the gap around a shaft to keep lint, dust and moisture out of the bearing area
• Helps maintain proper bearing lubrication and reduces premature wear
• Restores the intended barrier between the drum/motor shaft and the cabinet interior
• Can reduce noise or roughness caused by contaminated bearings when installed as part of a bearing service

• One bearing seal

• Disconnect power (and gas if applicable) before starting any repair
• Access may require removing panels, the drum or motor depending on model; follow manufacturer service instructions
• Inspect bearing and surrounding components and replace any worn parts to avoid repeat failure
• Use only OEM-recommended parts and avoid over-stressing the seal during installation

This front panel clip is a small replacement retainer that secures a stove/console or appliance front/trim panel in place, restoring a snug, rattle-free fit and proper panel alignment. What it does

• Secures the front/trim panel to the appliance housing or console
• Prevents the panel from sagging, shifting, or producing rattling noises
• Helps maintain correct panel alignment for buttons, switches, and seams
• Common fix if a front panel is loose or won't stay attached

• One front panel clip

• Disconnect power to the appliance before starting any work
• Access may require removing screws or trim pieces; handle painted surfaces carefully to avoid scratches
• Clip typically snaps into place; confirm proper engagement before reassembling
• If other fasteners are damaged or missing, replace them as needed for a secure fit

This drive belt turns the dryer drum by linking the motor pulley and idler assembly. Replacing a stretched or broken belt restores smooth tumbling performance and helps eliminate slippage noises so clothes can dry evenly. What it does:

• Transfers motor rotation to the drum for consistent tumbling
• Works with the idler/tensioner to maintain proper belt tension and grip
• Typical failure symptoms: drum won't turn, motor runs but drum is still, squealing or thumping noises, burning-rubber smell, or a visibly frayed/split belt
• On models with a belt switch, a broken belt can stop the dryer shortly after starting

• 1 drive belt

• Disconnect power; for gas dryers, also shut off the gas supply
• Access the belt by removing the top and front panels; support the drum when the front is off
• Release belt tension from the idler, note the routing, and install the new belt around the drum, idler, and motor pulley per your model's diagram
• Rotate the drum by hand to seat the belt before reassembly and testing