Parts for Ge TBHA22RRELAD: 02 - Section2 Parts

This trim recess assembly replaces the finished plastic trim around the refrigerator dispenser opening to restore appearance and secure dispenser components. It helps maintain a clean, snug fit between the dispenser and door surface. What it does:

• Provides the finished trim piece around the dispenser opening and hides mounting points
• Helps keep the dispenser bezel properly aligned and reduces gaps
• Addresses cracked, dented, or broken trim that affects appearance
• Prevents loose or wobbly dispenser parts caused by a damaged recess trim

• One trim recess assembly

• Disconnect power and shut off the water supply to the refrigerator before starting
• Remove the dispenser bezel/door panel to access the trim
• Handle plastic trim carefully to avoid cracking; use plastic-safe tools or trim tools as needed

Spring for recess duct. For spring sleeve use WR2X4822.

Includes 12 screws. Size: 8-18 ab.

The Fresh Food Door Gasket is an OEM part for GE refrigerators. It seals the perimeter of the refrigerator's fresh food door, maintaining the internal temperature by preventing warm air from entering and cold air from escaping. The gasket measures approximately 39-3/4 inches by 29-3/4 inches.

Over time, door gaskets can wear out or become damaged due to constant use, exposure to spills, or mishandling. A faulty gasket compromises the refrigerator's efficiency, leading to increased energy consumption and uneven cooling.

Symptoms of a bad fresh food door gasket include:

• The door not sealing properly
• Increased frost buildup inside the refrigerator
• Warmer than usual refrigerator temperatures
• Higher energy bills due to the refrigerator working harder to maintain cool temperatures

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This is a snap-in plug button used to replace a missing or damaged control panel or trim cap on compatible GE appliances. It restores a finished look and helps keep the underlying fastener or opening covered. What it does:

• Covers and protects a small access hole or fastener opening on the appliance surface
• Snaps into place to hold trim panels or control overlays secure
• Replaces worn, cracked, or missing buttons that affect appearance or allow debris entry
• Common symptom: visible hole or loose/missing plug on control panel or exterior trim

• One plug button

• Snap-in installation; press firmly into the opening until fully seated
• No tools typically required; use a soft cloth to protect finish while pressing
• If the surrounding area is damaged or warped, part may not seat correctly
• Disconnect power to appliance before working near energized controls or panels

The Screw is an OEM replacement part for GE refrigerators. Countless screws are used throughout the refrigerator to securely hold parts in place.

Symptoms of a bad or missing screw can include:

• Rattling or vibration noises coming from inside the appliance 
• Doors or other parts that are no longer properly aligned
• Increased frost or cold air leaks due to compromised seals

Causes may include normal wear and tear over time, accidental damage or loss of a screw during repairs, or improper assembly leaving crucial screws omitted. 

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore refrigerators.