Parts for Lg LTM9000ST / CS6ELGA: Section 2 Parts

This is a truss-head tapping screw used to secure trim, panels, and small assemblies on compatible LG appliances. It provides a low-profile, wide-bearing head that helps hold parts flush and resist pull-through. What it does:

• Fastens plastic and sheet-metal components where a self-tapping thread is needed
• Truss head spreads load to prevent damage to soft or thin materials
• Helps secure control panels, brackets, or trim pieces that require a low-profile head
• Common replacement when original mounting screws are missing, stripped, or corroded

• One truss-head tapping screw

• Use the correct screwdriver bit and moderate torque to avoid stripping the screw or workpiece
• Start threading straight and let the screw form threads without forcing at an angle
• Disconnect power and follow appliance-specific service safety procedures before working internally
• Replace any damaged mating threads or clips for a secure fit

A protective plastic or resin shield that covers the microwave's waveguide or other internal components from food splatter and damage. Located on the interior ceiling or side wall of the microwave, it should be replaced if cracked, burned, melted, or shows signs of arcing damage.

This is a small synchronous motor that drives the turntable inside the microwave, slowly rotating the glass tray to ensure even heating of food. It mounts beneath the microwave floor and connects to the turntable coupler. Replace this motor if the turntable has stopped spinning or rotates intermittently while the microwave is running.